Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Installation requirements
WARNING
2. Install male 0.5-in (1.3-mm) flare union
adapter to the 0.5-in (1.3-mm) NPT
If the information in this manual is not
internal thread at the regulator inlet. Use
followed exactly, a fire or explosion may
a backup wrench on the regulator fitting
result, causing death, personal injury, or
to avoid damage.
property damage.
When installing the range from the
-
Do not store or use gasoline or other
front, remove the 90 ° elbow for easier
flammable vapors and liquids in the
installation.
vicinity of this or any other appliance.
3. Install male 0.5-in (1.3-mm) or 0.75-in
- WHAT TO DO IF YOU SMELL GAS:
(1.9-mm) flare union adapter to the NPT
• DO NOT light a match, candle, or
internal thread of the manual shut-off
cigarette.
valve, taking care to back up the shut-off
• DO NOT try to light any appliance.
valve to keep it from turning.
• DO NOT touch any electrical switch.
4. Connect flexible metal appliance
• DO NOT use any phone in your building.
connector to the adapter on the range.
• Clear the room, building, or area of all
Position range to permit connection at the
occupants.
shut-off valve.
• Immediately call your gas supplier from
5. When all connections have been made,
Ins
a neighbor’s phone. Follow the gas
make sure all range controls are in the off
t
allation r
supplier’s instructions.
position and turn on the main gas supply
• If you cannot reach your gas supplier,
valve. Use a liquid leak detector at all
call the fire department.
joints and connections to check for leaks
equir
in the system.
-
Installation and service must be
performed by a qualified installer, service
WARNING
ement
agency, or gas supplier.
Do not use a flame to check for gas leaks to
Never use an old connector when installing
s
prevent death, personal injury, explosion,
a new range. If the hard-piping method is
and/or fire hazard.
used, you must carefully align the pipe; the
range cannot be moved after the connection
When using test pressures greater than 1/2
is made.
psig to pressure-test the gas supply system
of the residence, disconnect the range
To prevent gas leaks, apply pipe-joint
and individual shut-off valve from the gas
compound or wrap pipe-thread tape with
supply piping. When using test pressures
Teflon on all male (external) pipe threads.
of 1/2 psig or less to test the gas supply
1. Install a manual gas line shut-off valve in
system, simply isolate the range from the
the gas line in an easily accessed location
gas supply system by closing the individual
outside of the range.
shut-off valve.
Make sure everyone operating the range
knows where and how to shut off the gas
supply to the range.
26 English
Install_NX58J7750SS_AA_AC_DG68-00624A-06_EN+MES+CFR.indb 26
4/25/2016 9:47:24 PM
...