Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
fice English 5 Conversion 1. Use a 1/2" wrench to turn orifice clockwise until it stops (2 1/2 - 3 turns). Unlike the broil burner orifice, the bake burner orifice should be tightened as far as it will go in order to ensure that complete conversion has occurred. Air Shutter Bake Orifice Figure 2: Bake Orifice Fully seated Natural Gas Setting LP Gas Setting Figure 3: Bake Orifice Conversion Test the Installation Test for Gas Leaks Leak testing is to be conducted by the installer according to the instructions given in this section. Apply Leak Detection Fluid Turn on Gas. Apply a non-corrosive leak detection fluid to all joints and fittings in the gas connection between the shutoff valve and the range. Include gas fittings and joints in the range if connections may have been disturbed during installation. Bubbles appearing around fittings and connections indicate a leak. If a leak appears, turn off supply line gas shutoff valve and tighten connections. Retest for leaks by turning on the supply line gas shutoff valve. When leak check is complete (no bubbles appear), test is complete. Wipe off all detection fluid residue. CAUTION: Never check for leaks with a flame. Do not continue to the next step until all leaks are eliminated. Test Electric Ignition Turn on power at breaker Caution: If the display flashes and beeps, the polarity of the wiring may be reversed. Reversed polarity can damage the range and can result in electrical shock hazard. Immediately switch off power at the breaker and return to installation instructions. Test Cooktop Burners: Each burner must be tested for proper lighting, proper flame characteristics on the low setting and proper flame characteristics on the high setting. Test for proper ignition: English 6 Conversion 1. Push down and turn the knob to ignition symbol. 2. Verify that the ignitor/spark module clicks. 3. Once the air has been purged from the supply lines, verify that the burner lights within four (4) seconds. After burner lights, turn knob to the off position. 4. Test each rangetop burner in this fashion. Call Service if any of the burners do not light. Test flame characteristics on the low setting: 1. Push in and turn the knob to the ignition symbol until the burner ignites. 2. Turn knob to the low setting. 3. Verify that the burner maintains a minimum, steady, flame without going out. The flame should not lift or blow off of the burner. It should carry over, or surround, the entire burner. 4. Verify that the flame is the right color. It should be blue with an inner and outer cone. “Checking Flame Characteristics” on page 7 for more information. 5. Test each rangetop burner in this fashion. If any flame goes out, does not carry over properly or is too large, contact service. Test flame characteristics on the high setting: 1. Push in and turn the knob to the ignitor symbol until the burner ignites. 2. Turn knob to the high setting. 3. Verify that the burner maintains a steady flame. The flame should not lift or blo...
Эта инструкция также подходит к моделям:Плиты - HDI7132C/02 (1.35 mb)
Плиты - HDI7132C/03 (1.35 mb)
Плиты - HDI7132U/01 (1.35 mb)
Плиты - HDI7132U/02 (1.35 mb)