Оценок - 1, средний балл: 5 ( )

Производитель: Empire Comfort Systems Размер: 218.49 kb Название файла: Язык инструкции:

Place propane tank from cooker so that the hose length will not be in the way. Keep all connections and fittings clean, replace any damaged parts. 19. Never store the propane tank near high heat, open flames, direct sunlight or where high temperature exist. Assembly Instructions REQUIRED TOOLS: Pliers or adjustable wrench and screwdriver. 1. Bolt legs in place by inserting short bolts through holes in corners of main top, then through slot at top of leg. Screw nuts onto the bolts. Attach drip pan using four of the short bolts. Insert bolts through hole in center of leg and through corner of pan. Apply nuts and tighten securely. Now tighten leg bolts. 2. Install manifold clamps. Insert two long bolts through manifold clamp holes in the main top. Attach the two manifold clamps loosely (10,000 Btu per Burner) underneath top, using nuts. Place manifold pipe with valves attached into the clamps. Align the gas valves with center of large opening in top. The adjusting hood of the valve should face the rear of the stove. Now tighten the manifold clamps securely. Place the valve knobs on valve stem, making sure that the control valve is in the off position. Knob should be in the vertical position. Manifold Pipe thread is 3/8 male IPS. 3. To install burners: If stove is to be used with LP or bottled gas, the air shutter (round metal disc) should be partially opened and then locked in place by tightening the air shutter screw. The hole in open end of burner slides over the adjusting hood of the gas valve. The rear part of the burner is attached to hole underneath main top using long bolts with nuts. Fasten securely. 4. The grates are installed by inserting the two extended legs on grate into corresponding holes in main top on each side of burner opening. 5. Always use teflon tape or thread sealer on pipe threads. FOR MINI-STOVE MODELS (NUMBER MS-100, MS-200, MS300)) 6. Remove the main top by pulling upward. Install the two manifold clamps, using the long bolts with nuts, to the bottom front of frame. Do not tighten clamps. 7. Insert the manifold pipe with valves attached into the clamps; open end of manifold should extend through hole in left side of frame. Tighten the manifold clamps. Burners are fastened to burner hangers already installed. Then assemble in same manner as above. CHECK FOR GAS LEAKS After assembly is complete, connect stove to gas supply and check for gas leaks before lighting. Make sure proper fittings are used for connection. (To operate gas valve, push in before turning.) 1. Turn brass control valve so knob is in vertical position until it is tight. (This shuts off flow of gas from the regulator to the burner. 2. Open LP cylinder valve or gas supply by 1/4 turn. This allows gas into the regulator and stops it at the brass control valve. 3. Apply gas detector fluid (or soapy dishwashing solution) on all connections, especially around the regulator, valve and POL-cylinder GRATE BURNER TOP 1/4" BOLT 1/4" HEX FLANGE NUT BODY LEG Model No. S...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: