Оценок - 1, средний балл: 3 ( )

Производитель: DCS Размер: 2.17 mb Название файла: Язык инструкции:

Set aside. Replace the assemblies and retaining screws after the Self-Clean cycle has finished. 27" OVEN RACK SLIDE ASSEMBLY Wipe out puddles of grease and any loose soil that can be easily removed. Remove any soil that is outside the door seal area. This appliance is designed to clean the oven interior and that portion of the door that is inside the oven. The outer edges of the door and the oven cavity are not in the cleaning zone. Wipe this area clean before setting the oven to self-clean. 24 OVEN SELF CLEANING MODE ■ Turn on the ventilator hood above the range and leave it on until after the oven has completed the self-clean cycle. SETTING THE OVEN FOR SELF CLEAN 1) Push the "CLEAN"Selector Button. 2) Set Oven Control Knob to "CLEAN" ■ Cooling Blower turns on, ■ OVEN ON light and HEATING light turn on, ■ LOCK light turns on, ■ The door closing process takes approximately 60 seconds to complete, at which time the door becomes locked. AT THE END OF THE CLEAN CYCLE: The clean cycle takes 5 hours to complete. The OVEN ON light turns off once the cycle has finished. 1) Push the OFF selector button. The door latch will open automatically after the oven temperature falls below 550°F and the automatic door lock completes its 60 sec. cycle to the OPEN position. 2) Turn the oven control knob to OFF. Wipe white ash with a damp cloth or sponge (after oven has cooled) before placing oven racks. Fig. 13 3) Replace the oven rack slide assemblies by: A) Guiding the rear of the rack slide assembly into the bottom rear bracket of the oven side, B) Guide the top rear of the rack slide assembly into the top U-shaped bracket of the oven side, C) Lift up the Push Rod so that it rests on the "ledge"of the side support of the assembly, and D) Screw the assembly secure to the oven through the hole in the front middle section of the side support. Repeat for the other side of the oven. 4) Replace the oven racks. CAUTION: The interior of the oven will still be at baking temperatures when the lock light turns off and the oven door can be opened. Use caution as the oven may be hot enough to cause burns. 25 CARE AND MAINTENANCE WHEN CLEANING THE RANGE OR COOKTOP: Be careful cleaning any part of this appliance while hot. All parts of the appliance can be cleaned with hot soapy water, rinsed, dried and buffed to a shine with a soft, heavy pile cloth. Always try this first, as it is the mildest cleaning procedure. 1) Use the mildest cleaning procedure first. Some brands of cleaners of the same type are harsher than others, read their directions. A scent or a propellant can make a difference in the product, read the ingredients. Try on a small area first. 2) To avoid marring the surface always rub metal finishes in the direction of the polish lines. The cleaner will be more effective when used in the direction of the polish lines. 3) Use only clean sponges, soft cloths, paper towels, plastic non-metal or steel wool soap pads for cleaning or scouring (use only soap pads with soap still in them, an empty pad can scratch), as recommended in this section. 4) Be sure to rinse all parts thoroughly and to wipe dry to avoid water marks. BRAND NAMES In this section on cleaning, the use of name brands is intended only to indicate a type of cleaner. This does not constitute an endorsement. The omission of any name brand cleaner does not imply its adequacy or inadequacy. Many products are regional in distribution and can be found in local markets and department stores. COOKTOP Turn off all the burners and allow the grates to cool, before starting to clean the cooktop. If you wipe off any part of the cooktop while it is hot do so carefully as using a wet sponge or cloth can result in steam burns. BURNER GRATES When lifting the grates be careful as they are heavy. Place them on a protected surface, so they won't scratch the surface they are laid on. The burner grates are matte porcelain enamel over cast iron.When cool they may be placed in the dishwasher,or wiped clean while on the cooktop using hot soapy water, then rinsed and wiped dry. The burner grates will not rust as they are matte porcelain enamel on both sides for durability. The occasional use of mild abrasive cleansers such as Bon-Ami®, Soft Scrub® or a soap-filled steel wool pad is okay. Abrasive cleansers, used vigorously or too often, can eventually harm the enamel. Apply with a damp sponge, rinse thoroughly and dry. The porcelain may pop off the edge of the grates due to rapid temperature change when the burners are turned on. Do not be concerned as this does not result in the deterioration of the grates. The cast iron soon darkens to blend with the porcelain enamel. Be careful when wiping an area where the porcelain has popped off, as the edges may be sharp. 26 CARE AND MAINTENANCE Brass Ring Locating Pin Electrode Locating Pin Hole Inside Main Burner Port Ring Simmer Ring BURNERS For proper lighting and performance keep the burners ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: