Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
CHICAGO 60648 FORM 5S2514 01582 T T 0484/109/1M READ ALL INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE DAYTON HIGH PRESSURE HEATER! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE. General Safety Information WARNING: • IMPORTANT: READ AND UNDERSTAND INSTRUCTION MANUAL BEFORE STARTING OR SERVICING! • IMPROPER USE OF THIS HEATER CAN RESULT IN SERIOUS BODILY INJURY DUE TO HAZARDS OF FIRE OR EXPLOSION, CARBON MONOXIDE POISONING, BURN, AND ELECTRICAL SHOCK. • USE ONLY KEROSENE OR NUMBER 1 FUEL OIL. NEVER BURN GASOLINE, NAPHTHA, PAINT THINNERS, ALCOHOL OR OTHER VOLATILE FUELS! • USE ONLY IN AREAS FREE OF FLAMMABLE VAPOR OR HIGH DUST CONTENT. NEVER USE HEATER WHERE GASOLINE, PAINT THINNER OR OTHER HIGHLY FLAMMABLE VAPORS ARE PRESENT. • MAKE SURE HOT AIR OUTLET IS AT LEAST 8 FEET FROM COMBUSTIBLE MATERIALS. • FILL FUEL TANK OR MOVE HEATER ONLY WHEN HEATER IS UNPLUGGED. • NEVER USE HEATER IN ROOMS USED FOR SLEEPING. • USE ONLY IN WELL VENTILATED ROOMS. PROVIDE VENTILATION OF AT LEAST 3 SQUARE FEET FOR EACH 100,000 BTU OF RATING. (FOR EXAMPLE, A 30,000 BTU HEATER WOULD REQUIRE A TWO FOOT WIDE WINDOW RAISED SIX INCHES.) • WHEN USED WITH THERMOSTAT, HEATER MAY START ANYTIME! • KEEP CHILDREN AWAY FROM HEATER AT ALL TIMES — NEVER LEAVE A HEATER PLUGGED IN WITHOUT AN ADULT PRESENT IF CHILDREN ARE LIKELY TO BE PRESENT. • USE ONLY WITH ELECTRICAL VOLTAGE AND FREQUENCY SPECIFIED ON MODEL PLATE. • USE ONLY A PROPERLY GROUNDED THREE-WIRE EXTENSION CORD. • DO NOT MOVE, HANDLE OR SERVICE WHILE HOT OR BURNING. • USE ONLY IN ACCORDANCE WITH LOCAL ORDINANCES AND CODES. • NEVER ADD DUCT WORK TO FRONT OF HEATER. • SAFETY REQUIREMENTS AND MODEL PLATE DATA COMPLY WITH AMERICAN NATIONAL STANDARDS INSTITUTE SAFETY REQUIREMENTS. ANSI A 10-1970 Figure 1 Description The Dayton high pressure oii-fired heater is designed for use where large amounts of heat are needed. It must be used where adequate ventilation and proper electrical power are available. This manual contains operating, maintenance and trouble-shooting instructions for the heater. A complete list is included at the end of the manual. Specifications MODEL 3E358 BTU rating ..................... 350,000 per hour Air delivery ........................... 875 SCFM Voltage .....................115, 60 Hz, 1 phase Amperes: Starting ..........................28.0 Running ..........................7.1 Fuel ...................Kerosene or No. 1 fuel oil Fuel tank capacity ................30 U.S. gallons Nozzle ................2.50 GPH 70° hollow cone Motor ......................1/3 HP @1725 RPM Weight: Empty ..........................180 lbs. Full tank ........................ 390 lbs. Pump pressure ..........................100 psi MODEL 3E359 BTU rating ..................... 600,000 per hour Air delivery ..........................2500 SCFM Voltage .....................115, 60 Hz, 1 phase Amperes: Starting ..........................38.0 Running .........................10.0 Fuel ...................Kerosene or No. 1 fuel oil Fuel tank capacity ................36 U.S. gallons Nozzle ................4.46 GPH 80° hollow cone Motor ......................1/2 HP @ 1725 RPM Weight: Empty .......................... 285 lbs. Full tank ........................ 550 lbs. Pump pressure ..........................110 psi FORM 5S2514 MODELS 3E358 & 3E359 01582 Assembly 1. Remove the heater from its shipping container and take off any protective packing material which may be applied to it. 2. Check the heater for possible shipping damage. If any is found, IMMEDIATELY notify the agent of the carrier which delivered the heater to you and make out a claim for the damage. 3. Fill the fuel tank with the proper fuel. NOTE: If the heater is used at below zero temperatures, the fuel may congeal. To prevent this, add two tablespoons of Frostex or similar anti-icer to each 5 gallons of fuel. Be sure tank and fuel is water-free before filling. 4. Use heater only with adequate ventilation. If used in a closed room, a partly-opened door or window near the heater will provide enough ventilation. Do not use this heater as a source of heat in sleeping quarters. 5. Use only kerosene or No. 1 fuel oil; do not use No. 2 or heavier fuel oil as they contain tars which will contaminate the heater. DO NOT USE GASOLINE: IT IS VOLATILE AND DANGEROUS. 6. Use the heater only on the electrical power specified on the instruction plate. 7. Plug the heater into a grounded receptacle or use a grounding adapter. Be sure the heater is grounded whenever it is in operation and whenever you are working on or near it. 8. Keep the heater at least 8 feet from any combustible materials. 9. DO NOT use the heater in the presence of flammable vapors such as paint, gasoline, or solvents. 10. Never add fuel while the heater is operating. 11. Keep the air inlet and discharge areas free of loose materials and any obstructions that would hinder the free flow of ...
Эта инструкция также подходит к моделям:Плиты - 3E358 (717.24 kb)