Оценок - 4, средний балл: 4.8
(
)
)
|
Фрагмент инструкции
Then wipe them dry. • If you intend to use a chemically treated cleaning cloth, read its directions first. • Do not use alcohol or paint thinners. MDs: If the MD cartridge is dirty wipe it with a damp cloth and then wipe dry. When storing MDs, avoid locations which are • Exposed to direct sunlight. • Susceptible to high levels of humidity or dust. • Directly exposed to heat from a heating appliance. • On top of a car dashboard or near the rear window. Handling the MDs • Do not open the shutter. The shutter is usually locked to prevent opening. Do not force in to open, or the disc may be destroyed. Specifications Portable MINIDISC player Type : Minidisc digital audio system Sampling frequency : 44.1 kHz Compression/expansion method : ATRAC method Number of channels : 2 channels (stereo) Frequency response : 20 Hz to 20,000 Hz Wow & flutter : Unmeasurable Output : Headphone (3.5 mm dia. stereo . 1) 5 mW/ch at 10% THD/16 ohms to 47 kohms Duration of battery : Approx. 27 hours when using a rechargeable battery (BN-R1210) charged for 2 hours ; Approx. 43 hours when using an alkaline battery (LR6) ; Approx. 75 hours when using a rechargeable battery and alkaline battery together * Above duration may differ depending on the ambient temperature and conditions. Power requirements : DC 1.2 V (rechargeable battery), DC 1.5 V (R6 size battery) DC IN 1.5 V Dimensions (L . W . H) : 71.0 mm . 14.4 mm . 78.0 mm (Excluding buttons and controls) Mass : Approx. 61 g (without battery) AC adaptor (AA-R9020) Charger/adaptor (AC-R124) Input power source : AC 110-AC 230 V, Input power source : DC 9 V, 0.5 A 50 Hz/60 Hz Output voltage : DC 9 V, 0.5 A Output voltage : DC 1.5 V, 0.7 A Design and specifications are subject to change without notice. US and foreign patents licensed from Dolby Laboratories Licensing Corporation. Muting the pip tone When you press a button on the remote control except for the A.C.BASS and VOLUME (+, –) buttons, a pip tone is emitted. To mute the pip tone, while pressing the A.C.BASS button in Stop mode or during playback, press the P.MODE button. “BEEP OFF” appears on the remote control display. To resume the pip tone, do the same operation again. “BEEP ON” will appear on the display. Using the Minidisc Player with Optional Accessories Using the minidisc player with an audio system You can listen to MDs through your audio system. • After turning off the amplifier, plug a stereo connection cable (not supplied) into the headphones jack as shown below. • Adjust the volume of the minidisc player to an appropriate level. • Adjust the volume level on the amplifier. • Use the unit's buttons for operation. (The remote control will issue a Pip tone.) • Direct connection without passing through the remote control may generate noise. • Depending on the connected device, the sound may not be as loud as the sound from other sources. This is because the sound level has been adjusted for the headphones and is not a malfunction. Using the minidisc player with a car audio system You can listen to an MD through your car audio system. The following accessories are available for your car audio system. • Car adaptor (CA-R153) • Car audio cassette adaptor EN, CH JVC (Stop mode) Normal Play Follow the numbers in the figure to the right. 1 Connect the headphones plug firmly. 2 Connect the remote control plug firmly. 3 Make sure the switches on the unit and remote control are not on HOLD setting. 4 Load an MD. • Slide the OPEN switch to open the lid. • Open the lid by hand. • Insert the MD into the MD slot beneath the lid, with its label side facing up. Insert the MD until it stops. Be sure the % or ] mark on the MD aligns as shown in the figure. • Close the lid. “HELLO” appears on the remote control display. Then the track number and playback time appear. (If the lid is closed without inserting an MD, the sound of the motor can be heard for approximately one second. This is not a malfunction.) 5 Adjust the volume level between 0 and 25. Press the Volume (+, –) button on the unit or the remote control. 6 Press the 38 button. Playback starts from the first track and ends after playing all the tracks on the MD. Notes: • Insert the MD in the way that it will not touch the catch. If the catch is bent for some reason, the lid may not be closed properly. • When opening the lid, please hold it by the edge when an MD is already loaded. • If no MD is loaded, “No Disc” appears on the display, and the power will automatically shut off after approx. 10 seconds. • If the MD is recorded in Monaural mode, “MONO” will appear on the display. • To eject the MD, slide the OPEN switch and open the lid by hand. The MD will then come out. • When the remote control is connected, the power may automatically turn on. However, if left as it is, it will eventually turn off automatically. • This MD Player has a 40 second sound-skip-guard memory function to accomodate any shocks. Consequently, it can be used while walking. CAUTION: Before connecting the car ...
Эта инструкция также подходит к моделям:Плееры - XM-PX55RD (446.5 kb)
Плееры - XM-PX55SL (446.5 kb)