Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
(not included) PRECAUTIONS ON USING THE AC ADAPTOR Put in AC adaptor spec. Please make sure you purchase the correct AC adaptor. Use of an incorrect AC adaptor will damage the unit.Don’t touch the AC adaptor with wet hands. Doing so is dangerous, as this could result in an electric shock. If the adaptor plug is insert into the DC Jack of the Player, the power supply automatically switch to the AC/DC power and the batteries supply will be disconnected. DC OPERATION ALKALINE BATTERY INSTALLATION (NOT SUPPLIED) Insert two AA batteries (not supplied) into the battery compartment on the bottom of the unit. Be sure to observe the proper polarity. CHARGING AND USE OF RECHARGEABLE BATTERIES This unit can fully recharge the specified rechargeable batteries, in approximately 15 hours. The rechargeable batteries (NOT supplied) should be recharged before they are used for the first time or they have not been used for a long period of time (over 60 days). 1. Open the battery compartment cover and insert two of the recommended rechargeable batteries, matching polarity. (1.2V 650mA). ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM TYPE, OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK. 2. Plug in the AC adaptor. (not included) E.1 3. Slide the charge switch to ON position to start charging. The charge indicator will light up. USE ONLY THE AC ADAPTOR FOR CHARGING. 4. After 15 hours, please unplug the AC adaptor and slide the recharge switch to OFF position. DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO CAN CAUSE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES TO DETERIORATE. NOTE: You may play DISC’S whilst charging the batteries. If the operating time decreases drastically even when the rechargeable nickel-cadmium batteries are properly recharged, purchase a new set of rechargeable nickel-cadmium batteries. When charging for the first time or after a long time, playing time may be reduced. In this case, charge and discharge the batteries several times. NOTE ON ALKALINE BATTERIES 1. When replacing the alkaline batteries, use two new batteries of the same type. Do not mix a used battery with a new one or mix different types of batteries. 2. When inserting the batteries, be sure to place the batteries as the sketch shown, mistakenly inserting even one with improper polarity will cause leakage and the unit will not play properly. 3. When not using the unit for an extended period of time, or not using the batteries for a long time, remove them to prevent possible acid leakage or corrosion resulting in damage to your player or personal injury such as skin burns. 4. Bear in mind that battery life expectancy is based upon playing mode. Maximum battery power consumption happens at maximum settings. If sound gets distorted or if the unit fails to switch tracks, your batteries are weak. Replace both batteries, or use AC adaptor. (not included) 5. Never charge, heat, disassemble, or throw batteries into a fire. ”, this means your batteries are weak, replace them or use the AC adaptor. 6. If the display shows the symbol “ 7. If the display is blank - no numbers show when power is turned on, the batteries are dead. Replace them or use the AC adaptor. AUTO POWER ON FUNCTION The power turns on automatically when the PLAY/PAUSE button is pressed. AUTO POWER OFF FUNCTION When all the tracks on a disc have been played, or the Stop button is pressed, the power turns off automatically within 60 seconds if no button is pressed. If you pressed the Stop button twice the power will turn off LISTENING WITH HEADPHONES/EARPHONES Connect the plug of the stereo headphone/earphone into the headphone jack (marked phones) before use the unit. CAUTION: Hearing experts advise against exposure to continuous extended play at loud volume levels while using headphones, possible hearing loss may result. If you experience a ringing in the ears, reduce volume or discontinue use. We want you listening for a life time. PLAYING A DISC Be sure to reduce the volume before plugging in or unplugging the headphones/ earphones 1. Plug the cord of headphone/earphone into the PHONES jack. 2. Slide the Door Open button to open the CD door. E.2 HOLD VOLUME 5. PHONE JACK 6. VOLUME3. PLAY/ PAUSE 4.CD SKIP 3. Hold the disc with the label side up and press it onto the spindle until it “clicks” into place. 4. Close the disc compartment, press PLAY/PAUSE button, the disc will begin to spin, the display will indicate “01”, play will begin immediately from track number 1. 5. Adjust the volume as desired. 6. Set the BASS BOOST function as desired. 7. To stop play temporarily, press the PLAY/PAUSE button. • The track number flashes in the display. • Press the PLAY/PAUSE button again to resume. 8. To stop play, press the Stop Button, and the power turns off automatically after a while. Note:Both 8cm and 12cm discs can be played in the unit. Place only one disc at a time in the CD compartment. USING OF REMOTE CONTROL AUDIO 1. Hold key: It is useful during playing. The function ...