Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
120 s (sec.) with Sony cassette C-60 Frequency response TYPE I (normal): 80 - 10 000 Hz General Speaker Full range: 10 cm dia., 3.2 ., cone type (2) Input LINE IN jack (stereo minijack) (CFD-S550L only): Minimum input level 330 mV Outputs Headphones jack (stereo minijack): For 16 - 68 . impedance headphones OPTICAL DIGITAL OUT (CD) (Optical output connector) (CFD-S550L only): Wavelength: 630 - 690 nm Maximum Power output 5.2 W Power requirements For CD radio cassette-corder: Koreal model: 220V AC, 60 Hz Saudi Arabian model: 110 - 127V, 220 - 240V AC selectable, 50/60 Hz Other models: 230V AC, 50 Hz 9 V DC, 6 R20 (size D) batteries For remote control: 3 V DC, 2 R6 (size AA) batteries Power consumption AC 20 W Battery life For CD radio cassette-corder: FM recording Sony R20P: approx. 13.5 h Sony alkaline LR20: approx. 20 h Tape playback Sony R20P: approx. 7.5 h Sony alkaline LR20: approx. 15 h CD playback Sony R20P: approx. 2.5 h Sony alkaline LR20: approx. 7 h WARNING Sony Corporation ©2002 Operating Instructions CD Radio Cassette- Corder 3-249-673-41 (1) CFD-S550 CFD-S550L ABthe cabinet. Refer servicing to qualified personnel only. WARNING Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the appliance. Notice for customers in the United Kingdom A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, same rating fuse approved by ASTA or BSI to BS 1362, (i.e. marked with or mark) must be used. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. C 1 to AC IN 2 to the mains Power Sources D Connect the mains lead A or insert six R20 (size D) batteries (not supplied) into the battery compartment B . Notes • Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player. • To use the player on batteries, disconnect the mains lead from the player. • When you operate the player on batteries, you cannot turn on the player using the remote. Saudi Arabian model only: Adjusting the voltage C Be sure to set the VOLTAGE SELECTOR (at the bottom) to your local power supply. Tip Only for the customers supplied with an AC plug adaptor: Use the supplied AC plug adaptor if the plug of the mains lead does not match your outlet. Preparing the remote D Insert two R6 (size AA) batteries (not supplied). Replacing battery With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. Connecting optional componentsConnecting optional components Location of controls Listening to the radio Playing a tapePlaying a CD 1 Press RADIO BAND•AUTO PRESET until the band you want appears in the display (direct power-on). Each time you press the button, the indication changes as follows: CFD-S550: “FM” t “AM” CFD-S550L: “FM” t “MW” t “LW” 2 Hold down TUNE + or – until the frequency digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press the button repeatedly to change the frequency step by step. Tip If the FM broadcast is noisy, press MODE until “Mono” appears in the display and the radio will play in monaural. Changing the AM/MW tuning interval The AM/MW tuning interval is preset to 9 kHz at the factory. If you need to change the AM/MW tuning interval, do the following: 1 While keeping the RADIO BAND•AUTO PRESET button and x button pressed, disconnect the mains lead from the mains. 2 While keeping the RADIO BAND•AUTO PRESET button and x button pressed, reconnect the mains lead to the mains. The tuning interval is changed and “AM 9” “MW 9” or “AM 10” “MW 10” appears in the display for 2 seconds. After changing the tuning interval, you need to reset your preset radio stations. Presetting radio stations You can store radio stations into the player’s memory. You can preset up to 30 radio stations (CFD-S550), 20 for FM and 10 for AM in any order, or 40 radio stations (CFD-S550L), 20 for FM and 10 for MW and LW in any order. 1 Press RADIO BAND•AUTO PRESET to select the band. 2 Hold down RADIO BAND•AUTO PRESET for 2 seconds until “AUTO” flashes in the display. 3 Press DISPLAY•ENT•MEMORY. The stations are stored in memory from the lower frequencies to the higher ones. If a station cannot be preset automatically You need to preset a station with a weak signal manually. 1 Press RADIO BAND•AUTO PRESET to select the band. 2 Tune in a station you want. 3 Hold down the number buttons...