Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Do not apply too much force. Otherwise, the connectors may be damaged. Main unit Back of the front panel Notes • For safety, turn off the engine before cleaning the connectors, and remove the key from the ignition switch. • Never touch the connectors directly with your fingers or with any metal device. 33 01US07ADD-U.p65 33 1/20/00, 10:14 PM Dismounting the unit 1 Press the clip inside the front cover with a thin screwdriver, and gently pry the front cover free. 2 Repeat step 1 on the left side. The front cover is removed. 3 Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting. 4 Repeat step 3 on the right side. 5 Slide the unit out of the mounting. 34 01US07ADD-U.p65 34 1/20/00, 10:14 PM Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION 19 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 10 Hz to 20 kHz with no more than 1% total harmonic distortion. Other specifications Disc player section CD player (CDX-C8050X): System Compact disc digital audio system Signal-to-noise ratio 90 dB Frequency response 10 – 20,000 Hz Wow and flutter Below measurable limit MD player (MDX-C8500X): Signal-to-noise ratio Frequency response Wow and flutter Laser Diode Properties Material Wavelength Emission Duration Laser output power 90 dB 10 – 20,000 Hz Below measurable limit GaAlAs 780 nm Continuous Less than 44.6 W* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up Block. Tuner section FM Tuning range 87.5 – 107.9 MHz Antenna terminal External antenna connector Intermediate frequency 10.7 MHz/450 kHz Usable sensitivity 8 dBf Selectivity 75 dB at 400 kHz Signal-to-noise ratio 66 dB (stereo), 72 dB (mono) Harmonic distortion at 1 kHz Separation Frequency response AM Tuning range Antenna terminal Intermediate frequency Sensitivity 0.6 % (stereo), 0.3 % (mono) 35 dB at 1 kHz 30 – 15,000 Hz 530 – 1,710 kHz External antenna connector 10.7 MHz/450 kHz 30 .V Power amplifier section Outputs Speaker outputs (sure seal connectors) Speaker impedance 4 – 8 ohms Maximum power output 50 W . 4 (at 4 ohms) General Outputs Power requirements Dimensions Mounting dimensions Mass Supplied accessories Optional accessories Optional equipment Audio outputs Power antenna relay control lead Power amplifier control lead Telephone ATT control lead 12 V DC car battery (negative ground) Approx. 178 . 50 . 183 mm (7 1/8 . 2 . 7 1/8 in.) (w/h/d) Approx. 182 . 53 . 162 mm (7 1/4 . 2 1/8 . 6 3/8 in.) (w/h/d) CDX-C8050X: Approx. 1.3 kg (2 lb 14 oz) MDX-C8500X: Approx. 1.2 kg (2 lb 10 oz) Card remote commander RM-X91 Parts for installation and connections (1 set) Front panel case (1) Rotary commander RM-X4S BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) Compact disc single adaptor CSA-8 CD changer (10 discs) CDX-838, CDX-737, CDX-636 MD changer (6 discs) MDX-65 Other CD/MD changers with the Sony-BUS system Source selector XA-C30 TV tuner XT-40V U.S. and foreign patents licensed from Dolby laboratories Licensing Corporation. Design and specifications are subject to change without notice. 35 01US07ADD-U.p65 35 1/20/00, 10:14 PM Troubleshooting guide The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. General Problem Cause/Solution No sound. •Cancel the ATT function. •Set the front or rear fader control to the center position for two-speaker system. •Rotate the dial clockwise to adjust the volume. The contents of the memory •The power cord or battery has been disconnected. have been erased. •The reset button has been pressed. t Store again into the memory. Indications do not appear in the Remove the front panel and clean the connectors. See display. “Cleaning the connectors” (page 33) for details. No beep sound. The beep sound is canceled (page 29). The card remote commander •Remove any obstacles blocking the signal path from card does not function. remote commander to the unit. •Point the card remote commander at the receptor on the unit. 36 01US07ADD-U.p65 36 1/20/00, 10:14 PM CD/MD playback Problem Cause/Solution A disc cannot be loaded. •Another MD is already loaded. •The MD is forcibly inserted upside down or in the wrong way. Playback does not begin. Defective MD or dirty CD. CD/MD will not be ejected. You have closed the front panel or pushed the disc forcibly into the unit while the unit was ejecting the disc after you pressed (Z). t Press the reset button to initialize the unit. The operation buttons do not function. Press the reset button. The sound skips due to vibration. •CDX-C8050X: The unit is installed at an angle of more than 60°. MDX-C8500X: The unit is installed at an angle of more than 20°. •The unit is not installed in a sturdy part of the car. The sound skips. A dirty...