Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
marked with or mark) must be used. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. If you should lose the fuse cover, please contact your nearest Sony service station. About this manual The instructions in this manual are for the CFD-S45L, CFD-S47 and CFD-S47L. Before you start reading, check your model number. The CFD-S47L is the model used for illustration purpose. Note The name of the switch to turn on/off this player is indicated as below: “OPERATE”: European countries (excluding central and eastern Europe) “POWER”: Other countries 2EN Introduction Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape Basic Operations The CD Player 12 13 Using the display Locating a specific point in a track 14 15 16 18 Playing tracks repeatedly (Repeat Play) Playing tracks in random order (Shuffle Play) Creating your own program (Program Play) Enjoying sound effects (LOOP/FLASH) The Radio 19 20 Presetting radio stations Playing preset radio stations The Timer 21 Setting the clock 22 Waking up to music 24 Falling asleep to music Setting Up 25 Choosing the power sources 27 Selecting the audio emphasis (Sound Mode/MEGA BASS) Additional Information 28 Precautions 30 Troubleshooting 32 Maintenance 33 Specifications 34 Index EN 3EN Introduction Basic Operations Playing a CD 21 Connect the supplied AC power cord (see page 25). 1 Press 6CD OPEN/CLOSE CD OPEN/ CLOSE CD on the CD tray. With the label side up (direct power-on) and place the 2 Press ^. Display The CD tray closes and the player plays all the tracks once. Track number Playing time VOL– VOL+ PRESET+ BAND PRESET– TUNE – TUNE + 4EN Basic Operations Tip Next time you want to listen to a CD, just press ^. The player turns on automatically and starts playing the CD. Use these buttons for additional operations = ^ + p 6CD OPEN/CLOSE OPERATE (or POWER) To Press adjust the volume VOL +, – stop playback p pause playback ^ (Pon the remote, CFD-S47/S47L only) Press the button again to resume play after pause. go to the next track + go back to the previous track = remove the CD 6 CD OPEN/CLOSE turn on/off the player OPERATE (or POWER, see page 2) Basic Operations 5EN Basic Operations Listening to the radio 1 22 Connect the supplied AC power cord (see page 25). 1 Press BAND until the band you Display want appears in the display (direct power-on). VOL– VOL+ PRESET+ BAND PRESET– TUNE – TUNE + 2 Hold down TUNE +/+or TUNE –/=(TUNE + or – on the remote, CFD-S47/S47L only) until the frequency digits begin to change in the display. VOL– VOL+ PRESET+ BANDT– PRESETUNE – TUNE + The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press the button repeatedly to change the frequency step by step. Indicates an FM stereo broadcast 6EN Basic Operations Tips • If the FM broadcast is noisy, press MONO/ST ISS•PLAY MODE until “Mono” appears in the display and the radio will play in monaural. • Next time you want to listen to the radio, just press BAND. The player turns on automatically and starts playing the previous station. • CFD-S47 only: If a very strong station signal causes noise while listening to FM programs, set FM SENS at the rear to LOCAL. Normally, set it to DX. Use these buttons for additional operations MONO/ST ISS PLAY MODE VOL + VOL – OPERATE (or POWER) To Press adjust the volume VOL +, – turn on/off the radio OPERATE (or POWER, see page 2) To improve broadcast reception Reorient the antenna for FM. Reorient the player itself for AM or MW/LW. for FM for AM/MW/LW Basic Operations 7EN Basic Operations Playing a tape 12 Connect the supplied AC power cord (see page 25). 1 Press p6to open the tape STOP/EJECT With the side you want compartment and insert a to play facing upward recorded tape. Use TYPE I (normal) tape only. Close the compartment. 2 Press (. Display PLAY The player turns on (direct power-on) and starts playing. 8EN Basic Operations Tip Next time you want to listen to a tape, just press (. The player turns on automatically and starts playing the tape. Use these buttons for additional operations 0 ) p6 P VOL + VOL – OPERATE (or POWER) To Press adjust the volume VOL +, – stop playback p6 f ast-forward or rewind the tape )or 0 pause playback P Press the button again to resume play after pause. eject the cassette p6 turn on/off the player OPERATE (or POWER, see page 2) Basic Operations 9EN Basic Operations Recording on a tape 3 1 Connect the supplied AC power cord (see page 25). 1 Press p6to open the tape With the side you want to STOP/EJECT record on facing upward compartment and insert a blank tape. Use TYPE I (normal) tape only. 2 Select the program source you want to record. Display To record from the CD player, insert a CD (see page 4) and press pon the CD section. VOL– VOL+ PRESET+ BAND PRESET– TUNE – TUNE + VOL– VOL+ ...
Эта инструкция также подходит к моделям:Плееры - CFD-S47L (658.6 kb)