Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
The scroll speed will decrease and stop when finger releases. Add speed to the wheel or maintain the fast list scrolling speed if maximum scrolling speed is reached. 6 Tap Hold Stroke Swipe Install IMPORTANT Make sure to install the software supplied in the by-packed CD for music and photo transfer. System requirements: • Windows XP (SP2 or above) • Pentium Class 300MHz processor or higher • 128MB RAM • 500MB hard disk space • Internet connection (preferable) • Microsoft Internet Explorer 6.0 or later • USB port 1 Insert the CD supplied with your product into the CD ROM drive of your PC. 2 Follow the on-screen instructions to complete the installation of Windows Media Player (including necessary plug-ins) and Philips Device Manager. 3 If the installation program does not start automatically, browse the CD contents via Windows Explorer and run the program by double clicking on the file ending with .exe. IMPORTANT For US: There are two CDs and both are required for installation. Lost your CD? Don’t worry, you can download the CD contents from or (for U.S. residents). Connect and charge Your player will be charged when connected to the PC. Use the supplied USB cable Connect the supplied USB cable to PC for charging and data transfer. However, your PC must have hi-power capability in order to perform charging. Charge your player for at least 5 hours before using it for the first time. The battery** will be fully charged (100%) in 5 hours and 70% charged in one hour for quick charge. The player is fully charged when the charging animation stops and is displayed. Your fully charged player will allow up to 14 hours** of music playback. ** Rechargeable batteries have a limited number of charge cycles and may eventually need to be replaced. Battery life and number of charge cycles vary by use and settings. Battery level indication The approximate power levels of your battery are indicated as follows: Battery is full Battery is two-thirds full Battery is half full Battery is low Battery is empty When the battery is nearly empty, the following power low warning screen will blink and emit a beep tone. When you hear a double beep, your player will power down in less than 60 seconds. All settings will be saved before the player shuts down. Transfer You can transfer music and photos to your player using Windows Media Player. See Organize and transfer photos and music with Windows Media Player 10 section of this user manual for more details. Enjoy Power on and off To power on, slide down and hold ON/OFF LOCK slider to ON/OFF position until the player powers on. To power off, slide down and hold ON/OFF LOCK slider to ON/OFF position until the player powers off. Your player automatically powers off if there is no operation or music played for 10 minutes. The last playback status and screen will be resumed the next time it is powered on unless the player has been powered off for a long period of time or the battery level was low when the player was powered off. Demo mode The Demo mode is a screensaver to give you a quick introduction to the product. You may not need the demo mode after some use or you may prefer not to have the screensaver to increase your battery lifetime. The Demo mode can be turned off by accessing the Demo mode under the Settings menu and unchecking the box as shown. Organize and transfer photos and music with Windows Media Player 10 This chapter describes the steps that you need to follow to successfully transfer music and photos to your player. For more information, see Windows Media Player (WMP) Help on your computer. IMPORTANT Make sure you have installed the software provided in the by-packed CD for music and photo transfer. Music transfer You can add songs, organize songs into your playlists and manage your playlist using Windows Media Player 10. TIP We recommend that you always use Windows Media Player to transfer music to your player. However, if you prefer to use Windows Explorer, always make sure to copy your music into the Media > Music folder, otherwise the songs will neither show nor play on your player. Add songs to Windows Media Player Library Songs that are already on your computer 1 Start Windows Media Player by double clicking the following icon on your desktop. 2 3 2 Select Library tab to access media library 3 Click Add to Library on the bottom left of the screen. > You can choose to add files from folder, URL, by searching your computer, etc. 4 Select the desired files and add them to the library. Rip songs from a CD If you want to transfer music from a CD to your player, you need to create a digital copy of the music on your PC first. This is called ripping. 1 Start Windows Media Player. 3 4 2 Insert the Audio CD. 3 Select Rip tab to display a list of music tracks on your CD. If your computer is connected to the Internet, the album information will be automatically obtained so that you don’t have to enter the song titles and other in...