Оценок - 2, средний балл: 4.5
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
cannot be done. The remaining • This is due to the MiniDisc system limitation (in MD mode only). recording time does not Tracks of under 12 seconds (in SP mode), 24 seconds (in LP2 increase even after mode or monaural), or 48 seconds (in LP4 mode) in length are not erasing numerous short counted and so erasing them may not lead to an increase in the tracks. recording time. Symptom Cause/Remedy The total recorded time and the remaining time on the disc may not total the maximum recording time (60, 74, or 80 minutes). • This is due to the MiniDisc system limitation (in MD mode only). Normally, recording is done in minimum units of approximately 2 seconds (in SP mode), 4 seconds (in LP2 mode or monaural), or 8 seconds (in LP4 mode). When recording is stopped, the last unit of recording always uses this unit of 2 seconds, 4 seconds, or 8 seconds even if the actual recording is shorter. Likewise, when recording is restarted after the stop, the recorder will automatically insert a blank space amounting to 2 seconds, 4 seconds, or 8 seconds before the next recording. (This is to prevent accidental erasing of a previous track whenever a new recording is started). Therefore, the actual recording time will decrease whenever a recording is stopped by a maximum of 6 seconds, 12 seconds, or 24 seconds. “TRACK FULL” • This is due to the MiniDisc system limitation. Repeated recording appears even before the and erasing may cause fragmentation and scattering of data. disc has reached the Although those scattered data can be read, each fragment is maximum track number counted as a track. In this case, the number of tracks may reach or recording time. 2,047 (on a disc used in Hi-MD mode) and further recording is not possible. , To continue recording, erase unnecessary tracks. While playing Symptom Cause/Remedy A disc is not played normally. • Repeat play is selected. , Set the Repeat play to “RepeatOff” to change back to the normal play (page 40). • Playback mode is changed. , Enter the Main play mode or Sub play mode to change back to the normal play (page 36). A disc is not played from the first track. • Disc playing stopped before it came to the last track. , Press the 5-way control key (NENT) on the recorder for 2 seconds or more to start playing. Playback sound skips. • The recorder is placed where it receives continuous vibration. , Put the recorder on a stable place. • A very short track may cause sound to skip. , Try not to create a short track. Sound has a lot of static. • Strong magnetism from a television or such device is interfering with operation. , Move the recorder away from the source of strong magnetism. The volume of the recorded track is low. • The track was recorded in analog mode (in digital mode, the recording level is automatically set to the same level as that of the sound source). Or you used a connecting cord with an attenuator. , Use a correct connecting cord without an attenuator. • The recording level was low. , Adjust the recording level manually while recording (page 31). Symptom Cause/Remedy Volume cannot be turned up. • AVLS is on. , Release AVLS settings (page 55). No sound comes • The headphones/earphones plug is not firmly connected. through the headphones/ , Plug in the plug of the headphones/earphones firmly to i. earphones. • The plug is dirty. , Clean the plug. The disc cannot be played on another component • The component does not support Hi-MD. , Discs recorded on this recorder can be played only on components that supports Hi-MD. The edited tracks may • This occurs due to the MiniDisc system limitation. The exhibit sound dropout fragmentation of data may cause sound dropout while searching during search because the tracks are played in higher speed than normal operations. playback. There is no • There is no R-channel output if the cassette deck or an amplifier is R-channel sound output connected with a monaural cord. when playing a track , Make sure to use a stereo connecting cord. If, however, the recorded from a cassette connected equipment is monaural, there will be no R-channel deck or through an sound output even with a stereo connecting cord. amplifier, or when listening to sound from a cassette deck or amplifier. The recorder cannot play MP3 tracks. • You tried to play an MP3 track with a format not supported by this recorder. , This recorder only supports MP3 tracks (MPEG-1 Audio Layer-3/Sampling frequency 44.1 kHz) that have been transferred using the SonicStage software. Momentary noise is heard. • Due to the special digital audio compression technology used in LP4 mode, momentary noise may occur on very rare occasions with certain sound sources. While editing Symptom Cause/Remedy “NotENOUGH POWER TO EDIT” appears and editing cannot be done on a 1GB Hi-MD disc. • Editing is not possible when using a 1GB Hi-MD disc even when the battery level indication shows enough power remaining while the recorder is stopped or playing. This is because of a mechanism that disables editi...