Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Hearing experts advise that continuous use at high volume can permanently damage your hearing. Traffic safety: Do not use headphones while driving a vehicle. It may create a hazard and it is illegal in many countries. Even if your headphones are an open-air type designed to let you hear outside sounds, do not turn up the volume so high that you cannot hear what is going on around you. CD player and CD handling GENERAL INFORMATION / CD PLAY Only use the AY 3545 (4822 219 10033) or AY 3548 (3140 118 71890) car voltage converter (4.5 V DC, positive pole to the centre pin) and the AY 3501 car adapter cassette. Any other product may damage the set. 1 Put the set on a horizontal, vibration-free and stable surface. Make sure it is in a safe place, where the set is neither a danger nor an obstacle to the driver and the passengers. 2 Plug the voltage converter into the cigarette lighter socket (only for 12 V car battery, negative grounding), then connect the wired end with 4.5V DC input socket on the set. 3 If necessary, clean the cigarette lighter socket to obtain a good electrical contact. 4 Turn down the volume and connect the cassette adapter plug to p/LINE OUT on the set. 5 Carefully insert the cassette adapter into the car radio’s cassette compartment. 6 Make sure the cord does not hinder your driving. 7 Decease the volume on the set, if necessary. Start playback on the set and adjust the sound with the car radio controls. • Always remove the voltage converter from the cigarette lighter socket when the set is not in use. Note: If your car radio has a LINE IN socket , it is better to use it for the car radio connection instead of the cassette adapter. Connect the signal lead to this LINE IN socket and to p/LINE OUT on the set. 4,5 V DC 12 V DC PROG MODE LINE OUT OPEN In-car use (connections supplied or optionally available) CD PLAY / FEATURES • If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded properly, Error is displayed, indicating that the CD has not been finalized. In that case, use FINALIZE on your CD recorder to complete the recording. • When playing a CD-Rewritable (CD-RW), please note that it takes 3–15 seconds after pressing 2; for sound reproduction to start. • Playback will stop if you open the CD lid. • While the CD is read, rEAd is displayed. Volume and bass Volume adjustment • Adjust the volume by using VOLUME +/- on the cd player. Bass adjustment • Press DBB to switch the bass enhancement on or off y appears if the bass enhancement is activated. Playback information FEATURES You can store up to 30 tracks to play in a program. A single track may be stored more than once in the program. 1 In the stop position, press PROG to activate programming. ydisplay: PROG and 00 flash. 2 Press . or § to select your desired track number. ydisplay: PROG and your desired track number flash. 3 Press PROG to store the desired track number. ydisplay: PROG and 00 flash for you to program the next track. 4 Repeat steps 2 to 3 to select and store all desired tracks in this way. 5 Press 2; to start playback of your selected tracks. y PROG is shown and playback starts. • You can review the program by pressing PROG for more than 2 seconds. yThe display shows all the stored tracks in sequence. Notes: – If you try to store more than 30 tracks, FULL is displayed. Clearing the program • While playback is stopped, press 9 to clear program. yCLR is displayed once, program goes off, and the program is cleared. Note: The program will also be cleared if the power supply is interrupted, or if the CD-player lid is opened, or if the set switches off automatically. Programming track numbers FEATURES HOLD – locking all buttons You can lock the buttons of the set by switching the slider to HOLD. Now, when a key is pressed, no action will be executed. This is of use, for example, when transporting the player in a bag. With HOLD activated, you can avoid accidental activation of other functions. 1 Switch the slider to HOLD to activate HOLD. yAll buttons are locked. HOLD is shown when you press any button. If the set is switched off, HOLD will be shown only when 2; or FM is pressed. 2 To deactivate HOLD, switch the slider to OFF. HOLD This CD-player can play all kinds of Audio Discs such as CD-Recordables and CD-Rewritables. Do not try to play a CD-ROM, CDi, VCD, DVD or computer CD. 1 Push the OPEN cslider to open the player. 2 Insert an audio CD, printed side up, by pressing the CD onto the hub. 3 Close the player by pressing the lid down. 4 Press 2; to switch the player on and start playback. yThe current track number and elapsed playing time are displayed. • You can pause playback by pressing 2;. yThe time at which playback was paused starts flashing. • You can continue playback by pressing 2; again. 5 Press 9 to stop playback. yThe total number of tracks and the total playing time of the CD are displayed. 6 Press 9 again to switch the player off. • To remove the CD, hold it by its edge and press the hub gently while l...
Эта инструкция также подходит к моделям:Плееры - AX2481/17 (3.09 mb)