Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
Move the FUNCTION switch to TAPE OFF position with no cassette buttons pressed, to turn the unit off. VOLUME knob – Turn the volume knob to increase or decrease the volume. USING THE RADIO TUNING TO A RADIO STATION 1. Move the FUNCTION switch to TUNER to turn the radio on. 2. Set the BAND switch to FM or AM. 3. Tune to a desired station by turning the TUNING wheel knob. 4. To turn off the radio, move the FUNCTION switch to TAPE OFF. BEAT CUT SWITCH The BEAT CUT switch is also used for changing the FM reception mode. • Recording an AM station When recording an AM broadcast, beats may occur. If this happens, switch the BEAT CUT switch position to “1” or “2”. • Changing the FM reception mode When an FM stereo broadcast is hard to receive or noisy, switch to “MONO” (monaural). Reception improves. To restore stereo reception, switch to “FM ST”. USING THECASSETTE DECK REC – Press to record from the radio or CD player. PLAY – Press to play a cassette. REW – In stop mode, press to rewind the tape toward the beginning. FF – In stop mode, press to advance the tape toward the end. STOP/EJECT – Press to stop current tape activity, or to open the cassette compartment door when no buttons are active. PAUSE – Press to interrupt tape play or record mode. Press again to resume tape play or tape record mode. PLAYING A CASSETTE TAPE 1. Move the FUNCTION switch to TAPE OFF. 2. Press STOP/EJECT to open the cassette compartment door. 3. Insert a cassette into the compartment with the open edge down and the playback side facing out. 4. Close the door securely. 5. Press REW or FF to move the tape to the desired starting point. 6. Press PLAY to begin playing the tape. Playback continues until the tape reaches the end of the side, then automatically stops. RECORDING ON A CASSETTE TAPE You can record from the radio or the CD player. For best recording, use a normal bias tape. It may be unlawful to record or play back copyrighted material without the consent of the copyright owner. ERASE PROTECTION When you record new material, the cassette deck records over whatever is on the tape. To protect a tape from accidental erasure, break off one or both plastic tabs (one for each tape side) of the cassette. If you decide later to record on the tape, seal the hole with a piece of cellophane tape. WARNING A little bit of slack in your tape can cause scratches on the tape, or worse yet, the tape could break. If you notice some slack in the tape, use a pencil to tighten it up before you insert the tape in the cassette compartment. NOTE Use of tapes longer than 120 minutes is not recommended, since characteristic deterioration may occur and these tapes easily jam in the pinch roller and the capstan. RECORDING FROM THE RADIO 1. Insert a cassette into the cassette deck and close the door. 2. Move the FUNCTION switch to TUNER and tune to a radio station. 3. Press REC to begin recording. REC and PLAY both lock down. 4. Press STOP/EJECT to end recording. 5. To turn off the radio, slide the FUNCTION switch to TAPE OFF. RADIO RECORDING TIP To temporarily pause recording, press PAUSE . Press PAUSE again to resume recording. SYNCHRONIZED RECORDING FROM A CD 1. Insert a cassette into the cassette deck and close the door. 2. Move the FUNCTION switch to CD. 3. Insert the CD you want to record into the CD compartment. 4. Select the track you want to record by pressing (SKIP/SEARCH) or (SKIP/SEARCH). Then press REC . TIP Pressing PAUSE instead of STOP/EJECT to momentarily interrupt recording gives you a much cleaner sound recording. U USING THE CD PLAYER FUNCTION PROGRAM REPEAT (SKIP/SEARCH) STOP (SKIP/SEARCH) PUSH PLAYING A CD 1. Set the FUNCTION switch to CD. “– –” flashes, and then “00” appears in the display if no disc is loaded. 2. Press ) PUSH to open the CD compartment cover. 3. Place a CD on the tray with the label side facing up. 4. Close the CD compartment cover. The total number of tracks on the disc appears in the display. 5. Press . Playback starts from track 1. The current track number appears in the display. To pause playback, press . “PLAY” flashes in the display. Press again to resume playback. To stop playback, press 7 (STOP). Wait a few seconds for the disc to stop turning completely, and then remove the disc. To remove the disc, open the CD compartment cover, hold the disc by the edges, and carefully pull it out. SKIP The skip function lets you quickly locate the beginning of any track on the CD, including the track currently being played. During playback: • Press (SKIP/SEARCH) once to return to the beginning of the current track. • Press (SKIP/SEARCH) twice in rapid succession to return to the beginning of the previous track. • Press (SKIP/SEARCH) to skip to the beginning of the next track. In stop mode: Press (SKIP/SEARCH) or (SKIP/SEARCH) repeatedly until the display shows the desired track number, and then press . Playback starts from the selected track. SEARCH • During playback, press and hold (SKIP/SEARCH) to move forward through a...
Эта инструкция также подходит к моделям:Плееры - RC-ST1BK (412.63 kb)
Плееры - RC-ST1SL (412.63 kb)