Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Handling cassette tapes • Take up the slack of tape by inserting a pencil into one of the reels and rotating. If the tape is played without taking up the slack, it may get stretched, cut or caught in the cassette. • Be careful not to touch the tape surface. • Avoid storing tapes in the following places: – In dusty places – In direct sunlight or heat – In moist areas – On a TV or a speaker – Near a magnet Important for USB device Basic procedure Playback procedure 3 Select a station. • In SW reception, you can finely tune in a desired station by turning the FINE TUNING knob. 4 Adjust the volume. 1 Set the source to TUNER. 2 Select the band—FM/SW/MW. To stop playback • The tape also stops when it reaches its end. To pause playback • To resume, press 8 PAUSE again. To fast-forward/rewind a tape • When the tape reaches its end, press § STOP/ EJECT to release 1 FF or . REW. 1 Set the source to TAPE/ OFF. 2 Open the cassette holder, then load a cassette. 3 Close the cassette holder gently and start playback. 4 Adjust the volume. To use the beat-cut function When recording an MW broadcast, beats may occur. In this case, slide the BEAT CUT switch on the rear to select the beat-cut setting, 1 or 2. NOTES • It may be unlawful to record or play back copyrighted material without the consent of the copyright owner. • You can adjust the volume level while recording. The proper recording level is set automatically and it is not affected by the volume level. • If a TV is turned on and it is too close to the unit while recording, the recorded sound may have excessive noise. While recording, turn the TV off or keep the distance between the TV and the unit. Recording on a tape 1 Prepare the recording source. • For the radio recording: Set the source to TUNER and tune in to a desired station. • For the disc or USB device recording: - Set the source to CD/USB and load a disc or connect a USB device. - Select a track or program the playback order if necessary. (See “Program playback.”) • For AUDIO IN recording: - Set the source to AUDIO IN and turn on an external device. 2 Load a blank or erasable cassette. Use only a type-I (normal) tape. 3 Start recording. • 2 PLAY is also pushed down together with the ¶ REC button. • When recording from the disc/USB device, playback of the disc/USB device starts at the same time—Synchronized recording. To stop recording Press § STOP/EJECT. Recording also stops when the tape reaches its end. • For disc, USB device or AUDIO IN recording: – If the tape reaches its end first, the playback of the disc/USB device pauses automatically. However, the playback of an external device continues. – If the playback of the disc, USB device or external device stops first, recording continues. In this case, press § STOP/ EJECT to stop recording. Up to 20 tracks can be programmed to play in a desired order. To program the playing order While playback is stopped... 1 Show the program creation display. 2 Select a desired track. 3 Add the track to the program. 4 Repeat steps 2 to 3. 5 Start playback. • If you press 7 while you are programming tracks, the programmed order is erased. 1 Load a disc or connect a USB device. 2 Set the source to CD or USB. 3 Start playback. 4 Adjust the volume. To stop playback To pause playback • To resume, press the same button again. • When a USB device is played back, indicator appears on the display. • When a WMA file is played back, indicator appears on the display. To select a track To select a folder (for MP3/WMA) During playback... 1 Show the folder selecting display. 2 Select the desired folder while the indicator is flashing. To locate a desired position on the disc During playback... Adjusting the volume Turn the VOLUME knob to increase or decrease the volume. • Set the volume to minimum when you turn the unit on or start playing a tape. TUNER OPERATIONS Adjusting the antenna Improving the FM reception When an FM stereo (FM ST) broadcast is hard to receive or noisy, select the monaural reception (MONO). • To restore stereo reception, switch to FM ST. MW The MW antenna is built in, so adjusting the position of the unit may help MW reception. FM/SW GENERAL CONTROLS Basic procedure DISC/USB OPERATIONS Repeat/Random playback Select the desired playback mode. Each time you press the button, the playback mode changes as follows: Indicator Playback mode Repeats a single track/file.* Repeats files in a folder. (For MP3/WMA only) Repeats all tracks/files.* Plays tracks/files at random. • To cancel, press the same button repeatedly until the indicator above disappears from the display. * Repeat playback is also available during program playback. Erasing a tape Previous recording is overwritten when a new recording is made. To erase a tape without making a new recording 1 Set the source to TAPE/ OFF. 2 Start erasing. Program playback TAPE OPERATIONS Decrease Selecting the source to play Slide the FUNCTION selector to select CD/USB, TAPE/ OFF, TUNER or AUDIO IN. CD/USB: To play back a d...
Эта инструкция также подходит к моделям:Плееры - LVT2063-001C (808.15 kb)
Плееры - RC-EZ57 (808.15 kb)