Оценок - 4, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
It uses a 0 to 10 VDC current sinking for use with four-wire ballasts. It is designed for use with the RDA series of enclosures, in an AMX Lighting™ modular digital dimming system. The module’s 120 and 277 VAC ratings are CE, UL, and C-UL approved. Mounting points High voltage High voltage Low-voltage High voltage Low voltage Low voltage Caution: Pre-Installation Notes All Class 1 wiring must be connected to proper terminals. All control wiring must be connected to proper terminals. Disconnect power while installing or connecting the unit. Keep top and bottom air vents clear at all times. Use low-voltage wires with a 300 volt rating or greater. Use field installed copper conductors. All electrical ratings are for continuous duty. For indoor use only. Test loads for shorts before connecting. This module may require extra power from the AXlink connection or an external power supply connected to the control card. Connecting the RDM-3DC to the AMX Lighting Master Pin 4 (GND) Pin 3 (RLY) Pin 2 (DIM) Pin 1 (+12 V) RDM-3DC 4-pin module connector GND 3 (-) 2 (DIM) 1 (+) 4-pin plug from RDM series module Note: The 4-pin plugs from the module connector to the 4-pin connector on the master (black plug cover facing up). FIG. 2 Connecting the RDM-3DC and AMX Lighting Master Lighting Application Drawings Low-voltage control wiring: 4-pin connector to AMX Lighting master controller FIG. 1 RDM-3DC RDM-3DC UL and C-UL Ratings • 120 VAC, 50/60 Hz, 1920 W • 277 VAC, 50/60 Hz, 1920 W • Control Out: 50 mA, 12 VDC sinking Suggested Dimmed Loads • Four-wire dimmable ballasts, like Advance Transformer Mark VII™ or the Energy Savings SuperDim™ series Specifications • Dimensions (HW): 10" x 2.75" (25.4 cm x 6.99 cm) • Non-phase dependant • Use wires rated at 75°C (167°F) • Torque terminals to 20 in-lbs. (2.3 N/M) • Max. wire size: 10 AWG (4 mm2) • Wire stripping length: 0.28" (7 mm) • Weight: 2.9 lbs. (1.315 kg) • BTU/hr: 150 • Control current: 125 mA @ 12 VDC per control port Neutral Line in (HOT) Neutral The fuses protect the dimming circuit from a low impedance load. • The fuse will blow if it were incorrectly wired • Catastrophic ballast failure • Reversing switched and dimmed circuits • Reversing dimmed and line circuits. The dimmed output must be connected to a high impedance load. FIG. 3 RDM-3DC application wiring Warning: Failure to ground the ballast may cause ballast failure For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). 7/08 ©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX. AMX reserves the right to alter specifications without notice at any time. 3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624....