|
Инструкция по эксплуатации Brinkmann, модель SpotLigth
Производитель: Brinkmann Размер: 256.7 kb Название файла: 8206254f-5f2b-5a74-1da6-150fedc7db83.pdf
Язык инструкции:
|
|
|
|
Перейти к скачиванию
Фрагмент инструкции
Touching or wiping the surface will damage it permanently. • The lens is made of optical-quality, tempered glass. As with all glass, avoid dropping or sharp impact on spotlight. • Do not allow the hot lens to come in contact with water or materials subject to heat damage. • This spotlight is weather resistant. It is not waterproof. Do not use the spotlight under water or store outdoors. • Only use a Brinkmann 12-volt, halogen bulb that is designed for your Q-Beam spotlight. Use of any other bulb may result in poor performance and may damage your spotlight. • After months of use, cigarette lighters can build up corrosion that may prevent your Q-Beam spotlight from making good contact. It may be necessary to clean the inside of your cigarette lighter receptacle with a fine emery cloth. Before cleaning receptacle, remove the fuse to prevent it from shorting out. OPERATING INSTRUCTIONS READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL BEFORE OPERATING SPOTLIGHT. Step 1: To activate spotlight, plug the cigarette lighter adapter into a cigarette lighter receptacle. Move switch to ON. WARNING: Never place spotlight face down when light is on or is still hot from recent use. Doing so could burn/ignite surfaces such as seats, carpeting, etc. and cause major property damage. Always turn spotlight off and unplug from power source when not in use. Step 2: To deactivate, move switch to OFF and unplug from power source. Only use a Brinkmann halogen bulb that is designed for the Q-Beam Max Million II spotlight as a replacement. Use of any other bulb may result in poor performance and may damage your spotlight. IMPORTANT: Do not touch the glass part of bulb with fingers as natural oils affect the life and performance of bulb. Handle bulb by metal end only. Step 1: Disconnect spotlight from power source. Step 2: Remove the two screws from top and bottom of front housing (see Figure 1). Step 3: Lay the spotlight face (lens) down on a flat surface. Step 4: Holding the front housing secure, slowly lift the rear housing off being careful not to pull wire connections inside. Make sure the reflector is inside the front housing as shown in Figure 2. Do not touch the inside of reflector. NOTE: The glass lens is not attached to front housing. Use care when disassembling to avoid breaking lens. To Replace Bulb Rear Housing Reflector 2,000,000CANDLEPOWER MAXMILLION II LensFront Housing FIGURE 1 2,000,000 CANDLEPOWER Connector 2,000,000 CANDLEPOWER Connector FIGURE 3 00,000 LEPOWER Connector FIGURE 4 FIGURE 2 Step 5: Disconnect bulb wire from connector by holding the connector firmly with fingers then pulling bulb wire straight out as shown in Figure 2. Step 6: Spread the wire retainer apart and lift up as illustrated in Figure 3. Step 7: Pull bulb straight out from the reflector mounting plate. Step 8: To install new bulb, grasp the bulb from the metal end (DO NOT TOUCH THE GLASS PART) and insert into the reflector mounting plate. Align the slots in the bulb base with those in the reflector mounting plate. Step 9: Replace wire retainer by spreading ends apart while pressing down. Push ends together so they catch on the reflector mounting plate. Step 10: Reconnect the bulb wire to the connector as illustrated in Figure 4. Step 11: To reassemble spotlight, leave the front housing face (lens) down on a flat surface with the reflector in the front housing. Insert the rear housing into the front housing of the spotlight. Step 12: Replace the two screws that were removed in Step 2. Do not over tighten screws. Replacement bulbs and accessories may be purchased from The Brinkmann Corporation Consumer Sales Department by calling 1-800-468-5252. 4 Q-BEAM ACCESSORIES Pigtail Adapters Pigtail adapter with battery terminal clips allow Q-Beam spotlights with cigarette lighter plug to operate directly from a 12-volt battery. Model 802-1704-0 (2-Ft. Cord) Model 802-1705-0 (10-Ft. Cord) Rechargeable Battery Pack With Carrying Case 12-volt rechargeable battery pack adds total mobility to your Q-Beam. Includes cigarette lighter receptacle, 120-volt charging transformer and a heavy-duty, woven nylon carrying case with shoulder strap. Model 802-1724-1 Black Model 802-1725-1 Green Camo Lighter Plug Extension Cord Features a 15-ft. cord with a cigarette lighter plug and receptacle. Model 802-1706-0 LOOK FOR THESE ACCESSORIES AT YOUR LOCAL RETAILER WHERE Q-BEAMS ARE SOLD, OR ORDER DIRECT BY CALLING 1-800-468-5252. Replacement Bulb 12-volt, halogen bulb is an original replacement for Q-Beam Max Million II spotlight. Model 802-1746-0 Max Million II Spotlight ©2002 The Brinkmann Corporation Dallas, Texas 75244 U.S.A 1-YEAR LIMITED WARRANTY For 1-year from date of purchase, The Brinkmann Corporation warrants the Q-Beam Max Million II Spotlight against defects due to workmanship or materials to the original purchaser. The Brinkmann Corporation’s obligations under this warranty are limited to the following guidelines:...
Напишите ваш отзыв об устройстве
|
|