Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
Always keep the battery set (NC-200) fully charged especially before storage and prolonged periods of non-use. • Never use damaged or broken cord. • Short circuiting the battery's terminal with the charger's plug may cause overheat and damage the battery set. • The battery pack (NC-200) is restricted to use for this unit. Never use it with other products. • Avoid overdischarging the lighting system, e.g., switch it on until power completely run off. It will shorten the battery life. • Never charge the lighting system over 10 hours. • If the lighting system does not serve the proper running time on fully charged battery, the battery will have to be replaced. Replace with a new battery set (NC-200). • The beam heads' temperature is very high when the system is switched on and right after it is switched off. Be careful not to get burnt by the heat. Specifications Bulbs: Broad Beam: 6V-2.4W P13.5S halogen Spot Beam: 6V-10W P13.5S halogen Battery: NC-200 Sealed-Lead-Acid Rechargeable Battery Charger: Battery Charger CHR-6V4 Operation Time: 2.4W approx. 10-hour continuous use 10W: approx. 2-hour continuous use 2.4W & 10W: approx. 100 min. continuous use Charging Time: 8 to 10 hours Useable Temperature Range: When Charging: 0°C to 40°C When Operating:-15°C to 45°C Rechargeable Number of Times: At least 150 times (until rated capacity drops to 50%) Limited warranty This CAT EYE product is warranted under normal usage against defects in workmanship and materials to the original purchaser for a period of one year from the date of purchase free of charge providing the following conditions are met. Insurance, handling and transportation charges to our service department shall be borne by the person desiring service. This warranty shall be limited to the repair for the lamp unit and battery charger excluding the bulb, battery set, the bracket and other attachments. 1. This warranty certificate must be duly completed and stamped or signed by dealer to validate the warranty. 2. This warranty becomes void if the product shows evidence of (a) use contrary to the applicable instruction manual, (b) damages resulting from repairs, charges or disassembly performed by other than CAT EYE service department, (c) improper safe keeping/string, (d) drop and impact by a traffic accident and/or the like, (e) damages by fire, acts of God and earthquake. (To: U.S. Customer) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. 1) Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. 2) Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. (Service procedure) The service must be preformed by CAT EYE Co., Ltd. and the product which needs service must be returned to CAT EYE Co., Ltd. directly by purchaser. When returning the product for CAT EYE warranty service, please pack it very carefully, and enclose the warranty certificate so that the product can be shipped back to you as soon as the necessary repair is completed. (Address for service) 8-25, 2-chome, Kuwazu, Higashi Sumiyoshi-ku, Osaka Japan Attn.: CAT EYE Customer Service Section Phone: 81-6-719-7781 Fax: 81-6-719-2362 Mounting and Removing the Lamp Unit INSTRUCTION MANUAL RECHARGEABLE LIGHTING SYSTEM Introduction Thank you for purchasing the RECHARGEABLE LIGHTING SYSTEM Model HL-NC200. This Sealedlead- acid Rechargeable Battery powered lighting system can be used continuously by recharging the battery from home AC Power outlet. Before initial operation, read this manual thoroughly and familiarize yourself with the function of this product. Reserve this manual for your future reference. Note before use This lighting system can not be lighted or will not serve usual running time due to self discharge at initial use or after it is not used for a prolonged period. Be sure to recharge it before use. Overdischarging the battery, e.g., continuous light on until power completely runs off, will effect the battery function. Turn off the light and recharge the battery when beam turns dim. Name of Parts This lighting system consists of the following components. Make sure all the components are included in the package. R 1. Slide the lamp unit onto the mounted bracket until it clicks. 2. Plug the cord outlet from battery set into the jack on the lamp unit. Adjust cord length by putting extra cord into the battery bag or wind the cord around the frame. 3. To remove the lamp unit, slide it outward while pushing the lever on the bracket in the direction shown by the arrow. Mounting the Battery Bag 1. Take out the battery from the battery bag. Remove the plug cover and insert the plug of the cord into the jack on the battery set. 2. Put the plug cover back with the cord sent through the opening on it. 3. Put the battery set back into the bag. Tape the battery bag on the top tub...