Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
Back cover plate removed from the lamp housing. 3. Carefully remove the back cover, rubber gasket, and the retaining plate from the lamp housing. 4. Identify the bulb assembly connection and retaining cap inside the lamp housing, as shown in Figure 3. 5. To remove the retaining cap and bulb assembly from the reflective cone, push the cap down as you twist it counterclockwise. Note: Notice how the compression spring is mounted on the inside flanges of the retaining cap. 6. Slide the insulation sleeve surrounding the bulb assembly connection down the wire, then carefully pull the connection apart, as shown in Figure 4. retaining Cap & Spring Figure 4. Bulb assembly and retaining cap removed from the lamp housing. Re-connect the new bulb assembly, slide the insulation over the connection area, then reinstall the parts in the reverse order they were removed. Awarning Like all high intensity lamps there is potential danger when operating this lamp. Accidents are frequently caused by lack of familiarity or failure to pay attention. Use this lamp with respect and caution to decrease the risk of operator injury. If normal safety precautions are overlooked or ignored, serious personal injury may occur. Figure 3. Bulb assembly connection and retaining cap. If you need help with your new halogen lamp, call our Tech Support at: (570) 546-9663. -2- H6440/H6441 Halogen Lamp...
Эта инструкция также подходит к моделям:Осветительные приборы - H6440 (247.28 kb)
Осветительные приборы - H6441 (247.28 kb)
Осветительные приборы - H6440 (247.28 kb)