Войти:
Оценок - 4, средний балл: 4.8 ( )

Инструкция по эксплуатации Craftsman, модель 975815

Производитель: Craftsman
Размер: 147.4 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Turning off controls will good electrical condition; and not reduce this risk. c. That wire size is large enough for AC ampere • Do not use charger outdoors. rating of charger as specified below: • Disconnect charger from power supply when not in Cord Length (Feet) 25ft. 50ft. 100ft. 150ft. use, Cord Size (AWG) 16 16 16 14 SAVE THESE INSTRUCTIONS. Review them Note: AWG = American Wire Gage frequently and use them to instruct others who may use this light. If you loan someone this light, loan them these instructions also. CHARGING YOUR WORKLIGHT The battery pack and charger are not included with this worklight. They are both sold separately• If you decide to purchase a battery pack and charger, use battery pack part number 975284-001 and charger part number 975283-001. TO CHARGE BATrERY PACK: • Charge battery pack only with the charger recommended• • Make sure power supply is normal house voltage, 120 volts, 68 hz, AC only. • Connect charger to power supply. • Place battery pack in charger then press down on battery pack to be sure contacts on battery pack engage properly with charger contacts• • Red light should turn on. • When battery pack is fully charged, the red light will turn off and the green light will turn on. TO INSTALL/REMOVE BATTERY PACK See Figure 1. • Use 18.0 volt battery pack part number 975284-001 only. • Begin with a fully charged battery pack. Note: After normal usage, the battery pack requires 1 hour of recharge time. • Orient battery pack so that raised rib on battery pack aligns with groove inside worklight. Battery pack is designed to fit only one way in light handle• • Insert battery pack, making sure latches on each side of battery pack snap in place and battery pack is secure in light before use. • _ CAUTION: When placing battery pack in your light, be sure raised rib on battery pack aligns with groove inside light handle and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components. • To remove battery pack, locate latches on end of battery pack and depress to release battery pack from your light. BATTERY DEPRESSLATCHESTO RELEASEBATTERYPACK Fig. 1 2 SWITCH See Figure 2. To turn your light on and off, depress switch trigger. SWITCH TRIGGER MULTI-POSITION HEAD Fig. 2 MULTI-POSITION HEAD See Figure 2. Your worklight has the feature of a multi-position head that has positive stop clicks at each position. Rotate head to the desired position as shown in the arrows in figure 2. SAFETY RULES FOR WORKUGHTS WARNING: Do not operate flashlight or charger near flammable liquids or in gaseous or explosive atmospheres. Internal sparks may ignite fumes. WARNING: Lens and bulb become hot during use: • During or immediately after use, don't lay worklight flat on lens surface. • Handle worklight with care around any flammable surface. • If bulb has been lit, let worklight cool for several minutes before changing bulb. • Do not use or permit use of worklight in bed or sleeping bags. A burn injury could result. BULB REPLACEMENT See Figure 3. When purchasing replacement xenon bulb, request recommended part number 981258-001, TO REPLACE BULB: • Remove battery pack from workiight. • Remove the two screws securing lens cover, then remove cover. • Remove old bulb from spring. • Position new xenon bulb in spring. • Replace lens cover and screws. • Replace battery pack. Note: For your convenience, a bulb storage area with extra bulb has been provided. It is located behind the lens cover. See Figure 3. SCREWS BULB BULB STORAGE AREA LENSCOVER Fig. 3 To preserve natural resources, please recycle or dispose of properly. This product contains nickel- cadmium batteries. Local, state or federal laws may prohibit disposal of nickel-cadmium batteries in ordinary trash. Consult your local waste authority for information regarding available recycling and/or disposal options. Sears, Roebuck and Co., Hoffman Estates, IL 60179 For replacement parts information and ordering, call USA this toll free number: 1-eo0-366-PART (1-800-366-7278) 972000-671 5-99 ...

Эта инструкция также подходит к моделям:
Осветительные приборы - 315.110990 (147.4 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории