Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
6347). Specifically, this addendum: • Corrects the hardware hookup diagram on page 11. • Adds a note on page 16 defining which load types to choose when using expansion modules. Correction of Hookup Diagram The following diagram replaces the one that follows the paragraph on page 11 describing hardware hookup procedures. The diagram removes specific rating information for the circuit breaker supplying power to the iLux unit, and instead refers to the specifications to determine the appropriate rating. The diagram also includes information on the use of extension modules with the units. CLS-EXP expansion modules can be used in place of any or all loads shown above. Refer to expansion module documentation for wiring details. Refer to the CLS-C6 installation configuration diagrams on the previous page for connections to these Cresnet connectors. Addendum #1 for DOC. 6347B ilux™ Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 1 iLux™ Lighting System Crestron CLS/CLSI-C6 & CLS/CLSI-C6M Addition of Note Add the following at the beginning of page 16. The note defines the selection of load types when using expansion modules as loads on an iLux lighting system. NOTE: When using an expansion module for dimmed loads, choose the Incandescent load type; for non-dimmed loads, choose Non-dim. NOTE: For some expansion modules, low-end levels can be set either on the iLux unit or directly on the expansion module. Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ G7647 Tel: 888.CRESTRON Fax: 2G1.767.7576 Addendum #1 for DOC. 6347B 05.08 Specifications subject to change without notice....
Эта инструкция также подходит к моделям:Осветительные приборы - iLux CLSI-C6 (240.32 kb)