Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
For future reference, please complete the owner’s record below: __________ Serial No.___________ Purchase Date______________ SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you read the entire manual to become familiar with the unit BEFORE you begin assembly. Technical Specifications Tool Name: Spotlight, 1,000,000 Candle Power Item Number: 42417 Housing Diameter: 6" Battery: 12 VDC Lens Adapter: 5" Lens Construction: 3/16" Glass Candle Power 1,000,000 Light Source: Quartz Halogen Bulb Handle: 4" Pistol Grip Trigger: Squeeze Type with Trigger Hold Power Adapter: 120 VAC / 60 Hz<-> 12 VDC Charger: U.L. Listed Car Adapter: Lighter Type with 5-1/2' Cord Tool Weight: 3 LBS. Warning: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO THIS PRODUCT, BUT MUST BE SUPPLIED BY THE OPERATOR. The Operator PLEASE REMEMBER: Never look directly into the Spotlight. Avoid touching the Lens as it may become hot during operation. Do not dissassemble the Battery or remove any parts from the Battery and surrounding connections. Do not allow the Spotlight to be exposed to fire or high heat as this may result in an explosion. #42417 Page 2 Grounding/Voltage Warning Grounding/Voltage Warning NEVER try to plug a 110-120V tool into a 220-240V circuit or serious complications and possible injury to the operator may occur. The plugs have different shapes to prevent this. Assembly Your Spotlight comes completely assembled. Operation To assist you with operating your Spotlight please refer to Figure 1 on page 4 and to the Parts List and Assembly Diagram located on pages 4 and 5. Charging Your Spotlight Battery (#9) is rechargeable. To recharge your Battery (#9) your Spotlight comes with a Power Adapter (#13). Step 1) Insert the cord end of the Power Adapter (#13) into the outlet on the back of the Spotlight. Plug the Power Adapter (#13) into the electrical outlet. Step 2) The red light indicates the unit is properly plugged in. Leave the Power Adapter (#13) plugged in for approximately 12 to 14 hours until the Spotlight is fully charged. The red light will shut off automatically when the battery is fully charged. Recharging time is 8 to 10 hours. Always unplug the Power Adapter (#13) from the Spotlight after the Spotlight is charged. The Spotlight will not function properly if the Power Adapter is plugged into the Spotlight. Note: Always recharge the Spotlight within a 24 hour period after each use. Caution: Never completely discharge the battery. Deep battery discharge will decrease battery life. The battery capacity will be reduced if the Spotlight is not used for 3 months. It is recommended that the battery be re-charged at least one time every 3 months. Note:The battery should be charged before the first use. Car Adapter Your Spotlight comes with a Car Adapter (#14). To operate your Car Adapter follow the steps listed below. Step 1) Insert the cord end of the Car Adapter (#14) into the outlet on the back of the Spotlight. Plug the plug end of the Car Adapter Car Adapter (#14) into your car’s lighter -see Figure 1 on page 4. Leave the Car Adapter (#14) plugged in for approximately 9 to 12 hours until the Spotlight is fully charged. Recharging time is 5 to 8 hours. Step 2) Always unplug the Car Adapter (#14) from the Spotlight after the Spotlight is charged. The Spotlight will not function properly if the Car Adapter is plugged into the Spotlight. Note: When charging the Spotlight, only place the Spotlight on a non-flammable surface. Tripod Adapter Step 1) Your Spotlight can be screwed onto a tripod or workstand (neither is included). At the bottom of the Trigger Grip Handle there is Tripod Adapter (#6). Screw the tripod or workstand into this Tripod Adapter. #42417Rev 11/00 REV 10/02 REV 11/02 REV 05/03 REV 06/03 Page 3 On/Off with LockingTrigger Hold On/Off with LockingTrigger Hold e for work. Step 1) To turn on your Spotlight, press down on the Trigger (#11). Pressing down on the Trigger (#11) will engage the Locking Trigger Hold (#10)-see Figure 1. Note: Never leave Spotlight unattended with the Locking Trigger Hold left on. Step 2) To release the Trigger Hold (#10), push in on the left side of the Locking Trigger Hold button (#10) -see Figure 1. IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO NOT OPERATE THE TOOL. Lamp Lid (5) Car Adapter (14) Locking Trigger Hold (10) Trigger (11) Hanging Strap (12) Tripod Adapter (6) Unpacking UNPACK AND CHECK CONTENTS When unpacking your Spotlight-1,000,000 Candle Power check to make sure the following parts are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353. Parts Listing Part # Description Quantity Part # Description Quantity 1 ABS Housing 1 8 Switch 1 2 Reflector Plastic 1 9 Battery 1 3 Bulb 1 10 Locki...