Оценок - , средний балл:
(
)
)
Производитель: GE
Размер: 499.91 kb
Название файла: 1c848eb7-0bfc-4e96-b273-25056c2c0afc.pdf
Язык инструкции:
Документ загружается, подождите пожалуйста
 |
Документ загружается, подождите пожалуйста
Фрагмент инструкции
with one hand while pulling the power cord plug with the other hand. If this is not done, the adapter ground terminal is very likely to break with repeated use. If the adapter ground terminal breaks, DO NOT USE the dehumidifier until a proper ground has been established. Attaching the adapter ground terminal to a wall outlet cover screw does not ground the appliance unless the cover screw is metal, not insulated, and the wall outlet is grounded through the house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded. READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY. SAVE THESE INSTRUCTIONS 3 About the controls on the dehumidifier. Consumer Support Troubleshooting TipsOperating InstructionsSafety InstructionsTroubleshooting Tips Care and Cleaning Safety InstructionsOperating Instructions % Controls POWER Pad Press to turn the dehumidifier on and off. HUMIDITY CONTROL Pads The humidity level can be set within a range of 35% RH (Relative Humidity) to 70% RH (Relative Humidity) in 5% increments. For drier air, press the pad and set to a lower percent value (%). For damper air, press the pad and set to a higher percent value (%). When you first use the dehumidifier, set the humidity control to 45% or 50%. Allow at least 24 hours for the dehumidifier to achieve the humidity level. If you still have damper air than desired, set the humidity level to a lower setting. Other Features FAN SPEED Pad Controls the fan speed. Press to set to HIGH or LOW fan speed. Set the fan control to HIGH for maximum moisture removal. When the humidity has been reduced and quiet operation is preferred, set the fan control to LOW. HUMIDITY LEVEL DISPLAY Displays percent humidity level. Its accuracy is (+/– 5%). BUCKET FULL LED Indicates presence of bucket and its fill level. BUCKET FULL Light Glows when the bucket is ready to be emptied, or when the bucket is removed or not replaced in the proper position. Auto Shut Off The Water Level Control Switch shuts off the dehumidifier when the bucket is full, or when the bucket is removed or not replaced in the proper position. Also, when the bucket is out of position, the unit will beep 3 times. Auto Defrost When frost builds up on the cooling coils, the compressor will cycle off until the frost disappears. The fan continues to run. Power Outage If a power outage occurred or if the unit was unplugged, the unit will display its prior setting. Note: If ON is in the display, the dehumidifier is operating continuously, but a specific humidity level is not set. You will need to reset the HUMIDITY CONTROL to the desired level. Auto Restart Once power is restored after a power outage, the unit automatically resumes operation after a 2 minute delay. 4 There are 3 ways to remove collected water: Use the bucket. When the bucket is removed, the unit will shut off. Empty and replace the bucket. Use a hose. Water can be automatically emptied into a floor drain by attaching a water hose (not included) to the bucket hose nozzle. Using a drill, make a hole at the end of the nozzle located on the lower left side of the bucket. Attach a water hose to the bucket nozzle. Fasten by hand only. Use a floor drain. The unit can also be placed over a floor drain. Using a drill, make a hole at the end of the nozzle located on the lower left side of the bucket. NOTE: The nozzle cannot be fixed after puncture. Use an ordinary garden hose cap (not included) to reclose if necessary. NOTE: Avoid using mechanical tools to tighten the water hose to the bucket nozzle. This may damage the threads on the nozzle. Always make sure the water bucket is locked into place on the dehumidifier. Installing the Water Bucket Lift the bucket and hook the slots on each side onto the posts on the back of the dehumidifier. The bucket should lock securely in place. Make sure the bucket is locked securely in place by pressing down on the upper back edge of the bucket. It will be firmly seated when properly installed. Water Level The dehumidifier will turn off automatically when the bucket is full, or when the bucket is removed or not replaced in the proper position. The bucket must be replaced in the proper position for the dehumidifier to work. The light will be on and the dehumidifier will not run if the bucket is not in the proper position. Consumer Support Troubleshooting Tips Operating Instructions Safety Instructions Care and Cleaning Using the dehumidifier. Post Post Removing Collected Water Drill Nozzle Hose Attach hose: 6 Drill hole: Drill Consumer Support Troubleshooting TipsOperating InstructionsSafety InstructionsTroubleshooting Tips Care and Cleaning Safety InstructionsOperating Instructions Troubleshooting Tips… Troubleshooting Tips Save time and money! Problem Possible Causes What To Do Dehumidifier The dehumidifier • Make sure the dehumidifier’s plug is pushed completely does not start is unplugged. The fuse is blown/circuit breaker is tripped. Dehumidifier has reache...
Эта инструкция также подходит к моделям:Осушители воздуха - AHW30LH, AHH40LH (499.91 kb)