Оценок - 1, средний балл: 4 ( )

Производитель: Goldstar Размер: 884.96 kb Название файла: Язык инструкции:

Power --- Operation starts when this button is pressed and stops when the button is pressed again. Humidity Control --- This button controls the humidity in the room. • : To raise the humidity setting • : To lower the humidity setting • The humidity setting can be set to a permanent "On" setting or to a specific humidity setting between 35% and 70% in 5% increments. "On" setting - dehumidifier runs continuously regardless of humidity condition. 35% - 70% setting - dehumidifier shuts on and off according to surrounding humidity conditions. Fan Speed --- This controls the speed of the airflow. • High: Fan speed is set to high. • Low: Fan speed is set to low. • When Fan Speed button is pressed, the fan speed mode is changed. Energy Timer --- Press this button to select type of operation. • Select Constantly On for uninterrupted operation. • Select either 2 or 4 Hr. On/Off for cycled operation: The unit will operate for 2 or 4 hours, and then shut off completely for 2 or 4 hours. The cycle repeats until you change the setting. • When Energy Timer button is pressed, the Timer indicator lights shift as follows: Continuous On . 2 Hr. On/Off . 4 Hr. On/Off . Continuous On. Auto Restart --- Once power is restored after a power failure, the unit returns to its previous operation setting. The fan turns on immediately but, humidity control starts after a 2 minute delay. TO OPERATE THE DEHUMIDIFIER: 1. Plug the power cord into an electrical outlet. Press the power button. 2. Set the humidity Control to "On" or to a specific humidity level between "35% RH(Relative Humidity) and 70%RH(Relative Humidity)" for normal operation. If you need drier air, press the Humidity Control button. If you need less moister air, press the Humidity Control button. 3. Press the Power button to stop the unit manually. 4. Press the Timer button to set the amount of time you want the unit to run. At the end of that time, the unit will shut off. The Timer can be set for : Continuous On, 4 hours or 2 hours. 5. If you want to control the speed of airflow, press Fan Speed button. Each time that the Fan Speed button is pressed, the fan speed mode is shifted: High . Low . High Note: Be careful not to lose the water bucket. This dehumidifier doesn't run if the water bucket is not installed properly. 6 7 Water level control switch Drill Automatic shut off The dehumidifier will turn off automatically when the bucket is full, or when the bucket is removed or not replaced in the proper position. The bucket must be replaced in the proper position for the dehumidifier to work. The light will be on and the dehumidifier will not run if the bucket is not in the proper position. Disposing of collected water 1. Empty the bucket manually. When the bucket is full, pull out and empty it into a large sink or tub and then replace it properly. NOTE: Do not overtighten the hose when connecting it to the bucket. Use a rubber washer and tighten by hand firmly without stripping the plastic threads. NOTE:Be careful while taking out the bucket as it can cause damage. NOTE:Please do not shake strongly when you carry the bucket. It can cause to breakage of the handle or bucket cover. It is advisable to carry the bucket by supporting it from the bottom. 2. The bucket has a threaded hose connection which can be left open. Drill a 1/4" (6.4 mm) hole in the center of the hose connection. Once opened, the hose connection will continually drain water from the bucket. NOTE: The nozzle cannot be fixed after puncture. Use an ordinary garden hose cap to reclose if necessary. NOTE:When inserting the bucket into the unit. lifting up the bottom tip of the bucket lightly makes insertion easily. When being attached to the bucket drain hose connection, be sure the hose doesn’t kink or bend. It should lie flat from the dehumidifier to the drain. NOTE: The hose attachment will accept a standard garden hose filling. You can attach a screw-on cap to use the bucket without a hose. Attach a length of garden hose to the threaded bucket drain hose connection to carry water to the drain. 8 12" 12" Brush etc. Upside Upside Installation Instructions Installing the dehumidifier properly 1. Allow at least 12 inches of space on all sides of the unit for good air circulation. 2. Install your dehumidifier on a floor, table, or shelf. When installing the dehumidifier on a table or shelf, make sure the table or shelf is strong enough to support the weight of the dehumidifier with a full bucket. Do not sit or stand on the dehumidifier. NOTE: The height of a table or shelf might provide a better position from which to handle the bucket and help prevent icing of the coils due to colder air near the floor (such as in a basement.) 3. Lift the bucket and place it in the dehumidifier, making sure the slots on the bottom side of the bucket are positioned correctly. 4. Rollers let you move the dehumidifier easily. The cleaning of bucket 1. Pull out the bucket cover. 2. Brush off the filth in the bucket. NOTE: Please ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: