Оценок - 4, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
DO NOT use it in areas where gasoline, paint, or flammable liquids are used or stored. 12. Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not recommended or sold by The Holmes Group may cause hazards. 13. DO NOT use outdoors. THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC (Alternating Current)PLUG (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact qualified personnel to install the proper outlet. DO NOT DEFEAT THE SAFETY PURPOSE OF THIS POLARIZED PLUG IN ANY WAY. 14. To prevent a possible fire, DO NOT block air intakes or exhaust in any manner. DO NOT use on soft surfaces, like a bed, where openings may become blocked. 15. To disconnect heater, turn controls to OFF, then remove plug from outlet. 16. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord shall be No. 14 AWG minimum size and rated not less than 1875 watts. 17. If the heater will not operate, see specific instructions on Auto Safety Shut-off. 18. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only. PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS AUTO SAFETY SHUT-OFF WITH CERAMIC CONTROL This heater is equipped with a patented, technologically-advanced, safety system that requires the user to reset the heater if there is a potential overheat situation. When a potential overheat temperature is reached, the system will automatically shut the heater off. It can only resume operation when the user resets the unit. To Reset the Heater: 1. Turn MODE to OFF, and slide switch to manual. 2. Unplug the heater and wait 10 minutes for the unit to cool down. 3. After the 10 minutes, plug the unit in again and operate normally. PRE-OPERATING INSTRUCTIONS 1. Carefully remove your heater from the box. (please save the carton for off-season storage). 2. Make sure the unit is in the OFF position before plugging the heater into the outlet. 3. Place heater on firm level surface. 4. Avoid overloading your circuit by not using other high wattage appliances in the same outlet. At 1500 Watts, this unit draws 12.5 Amps. ACCUTEMP™ DIGITAL THERMOSTAT Your heater is equipped with an AccuTemp™ Digital Thermostat that allows you to set your heater to your precise comfort level. Setting the AccuTemp™ thermostat: 1. Make sure the Manual/AccuTemp™ switch is set to AccuTemp™. The LCD display will read 65°. 2. Turn the mode control to LO (750 watts) or HI (1500 watts). 3. Push the temperature set button until the display reads your desired temperature. To increase the temperature push the top button, for lower temperatures push the lower button. When finished setting the temperature, release the button and the display will flash to indicate the thermostat will be set to that temperature. 4. The display will return to existing room temperature and gradually increase until the room has reached your pre-set temperature. 5. If the unit will not start in the AccuTemp™ mode, please make sure the “set temperature” is higher than the current room temperature. NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting. When the preset temperature is made, the fan will run for 30 seconds without heat. This cool down process ensures an accurate and consistent temperature reading. If you unplug the heater, you will have to reset the AccuTemp™ thermostat again by following the above instructions. Manual Operation: 1. If you want the heater to run continuously, turn the Manual/ AccuTemp™ switch to Manual and adjust the mode control to LO, or HI. OSCILLATION INSTRUCTIONS 1. Turn the MODE control to the desired comfort setting and switch the oscillation button ON. 2. To stop oscillation, switch the oscillation button to OFF. 3. Please do not manually turn the unit; it is designed to turn only by motorized oscillation. CLEANING/MAINTENANCE During Season Care: Always unplug the heater, before moving or cleaning. 1. Carefully wipe the unit with a soft, damp cloth. Please be very cautious near the motor and heating elements. 2. NEVER use abrasive or flammable solvents to clean the unit. 3. After cleaning, be sure to completely dry the unit with a cloth or towel. After Season Care: 1. Store heater in a cool, dry location. 2. Holmes recommends that you store the unit in its original carton. TROUBLESHOOTING If your heater fails to operate: • Make sure the electrical outlet or circuit breaker is wor...