Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Turn the camera on by pressing and holding the MODE button until the display comes on and the camera beeps. To turn the unit off, press and hold the MODE button until the display goes out. The camera will turn itself off automatically to save batteries if none of the buttons have been pressed for three minutes. ADJUST THE BINOCULAR FOR COMFORTABLE VIEWING Adjust the center focus wheel (located between the eyepieces on the bottom of the camera) while viewing a distant object through the binocular, until it appears sharp. Holding your ImageView by the raised dot and ridge grip areas, carefully slide the left and right sides of the camera farther apart or closer together until you see a single circular image through the eyepieces. Rotate the diopter adjustment (dial with index marks on the bottom front of the ImageView) to find the best setting for your vision if the image does not appear as sharp to your right eye as it does for your left eye (close your left eye while you turn the dial, then check with both eyes open). Note the index settings for your eyes on both this diopter adjust dial and the IPD scale that is visible when the left/right halves are slid apart. This will make it easier to reset later if someone else uses your ImageView. CHECK CAMERA SETTINGS Make sure the camera is set for high quality (“LQ” does not show on the LCD display-see full instructions for setting photo quality) if you want the best results, especially if you will be printing the photos. See “Changing Operational Modes” for full instructions in using features such as repeat shot, movie clips (avi mode), and deleting a photo you have just taken. 7/19/04 8:50:22 AM TAKE A PHOTO (TIPS FOR BETTER QUALITY PHOTOS) With the camera turned on, press the SNAP button to take a new photo. For best results, hold the ImageView steady using both hands, and lightly press down the SNAP button using the flat end of your finger rather than “punching” it with a fingertip. For normal photos of distant objects over 25 feet (8 meters) away, leave the 2-position focus switch at the front of the camera on the “mountain” icon (left position). If you need to take photos of closer objects, set the focus switch to the “flower” icon (right position). This will change the camera focus to a range from approx. 10 to 25 feet (3-8 meters). Be sure the focus switch is set back to the normal (mountain) setting when you are no longer taking close range photos. USING THE IMAGEVIEW WITH YOUR COMPUTER BEFORE CONNECTING THE IMAGEVIEW TO A COMPUTER, first install the driver from the CD-ROM as directed in “Software Installation”. After the driver has been installed, you may install Roxio“ PhotoSuite 5 as well, following the on-screen instructions (if you do not already have photo software you prefer to use). Connect the supplied USB cable between the ImageView and your computer, using a USB port on the computer itself (avoid “hubs”). Please read “Downloading Photos to Your Computer” for detailed instructions on transferring photos to a PC using PhotoSuite. 11-0718 6LIM.indd 6-7 Congratulations on your purchase of a Bushnell ImageView binocular. Before using the product, please read these instructions and take time to familiarize yourelf with the different parts and features of the product. BINOCULAR INSTRUCTIONS TURNING THE CAMERA ON AND OFF Insert 2 AAA alkaline batteries as indicated on the inside lid of the battery compartment, located at the side of the left eyepiece. Turn the camera on by pressing and holding the MODE/POWER( ) button until the display comes on and the camera beeps. To turn the unit off, press and hold the MODE/ POWER( ) button until the display goes out. The camera will turn itself off automatically to save batteries if none of the buttons have been pressed for three minutes. MODE / POWER (On/Off) SNAP OK (Shutter Release) 7/19/04 8:50:24 AM TAKING A PICTURE With the camera turned on, press the SNAP button to take a new photo. For best results, hold the ImageView steady using both hands, and lightly press down the SNAP button using the flat end of your finger rather than “punching” it with a fingertip. For normal photos of distant objects over 25 feet (8 meters) away, leave the 2-position focus switch at the front of the camera on the “mountain” icon (left position). If you need to take photos of closer objects, set the focus switch to the “flower” icon (right position). This will change the camera focus to a range from approx. 10 to 25 feet (3-8 meters). Be sure the focus switch is set back to the normal (mountain) setting when you are no longer taking close range photos. CHANGING OPERATIONAL MODES Pressing the MODE/POWER( ) button briefly will cycle through several special camera modes and settings. A corresponding icon or symbol (indicated in parentheses below) will be displayed on the LCD for each mode as you cycle through them by tapping the MODE/POWER( ) button, and blink unless you select or confirm it with the OK button (icon will stop blinki...