Оценок - 5, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
These conditions are descdbed below. Read this section and be aware of the purpose of this safety mechanism at all times; do not tamper with its working. _lb WARNING:operate the ridingmower if the safety intedock To avoid serious injury, do not system is malfunctioning. The purpose of the safety intedock system is four-fold: a. to prevent the engine from starting unless the brake pedal is depressed; b. to shut off the engine if the blade control lever is not disengaged when the shiftlever is put into reverse; c. to shut the engine off when the operator leaves the seat without engaging the parking brake; d. to shut the engine off if an attempt is made to cut grass without the grass catcher propedy attached to the unit. Seat Switch: This switch is located under the seat and is a safety mechanism. When the parking brake is disengaged and blade control lever engaged, the operator must remain seated at all times for the engine to run. If he/she leaves the seat without disengaging blade control lever and turning engine off, this switch will automatically shut the engine oft regardless of whether the parking brake is engaged. Reverse Switch: This switch is located near the shift lever and will automatically shut off the engine if the blade control lever is moved to (ON) position when the shift lever is in (R). That is,the vehicle will not move in reverse direction withthe blade controllever engaged. 10 Brake Switch: This switch is located under the brake pedal assembly. The engine will not start without first depressing the brake pedal. This switch will also shut off the engine if the operator attempts to get off the unit without setting the parking brake, Blade Control Switch: This switch is located in the steering column. If the operator attempts to start the engine, get off the seat or remove grass bag with the blade control lever stillengaged, it will shut engine off. Grass Bag Switch: This switch is located in the bulkhead behind the engine. If the operator attempts to cut grass when the grass catcher is not properly attached to the vehicle, itwill shut engine off. Before Starting Filling Up Oil Check oil level inthe engine oilsump before starting the engine. (Oil sump capacity: 22 ozJ0.65 liter) 1. Place the vehicle on level ground and flip the seat up to access the engine. 2. With a dry rag, clean the area around the oil fill on the engine. 3. Remove dipstick and wipe it clean with cloth. 4. Replace and tighten the dipstick. Remove the dipstick again and check the oil level mark on it. The oil level should be at FULL line on the dipstick. If the level is short of that, add oil to the oil fill slowly. Recheck the oil level on the dipstick. If needed, add more oil. Do not overfill. NOTE: The lawn utility vehicle is shipped with oil in the engine crankcase. 5. Place the dipstick inposition and tighten to secure. Type of Oil SAE Viscosity Grades lIll _mi[llvdE_ °F -20 ° O° 20 ° 3240 ° 60 _ 80 ° 100 ° 3tading temperature range anticipated before next oil change *CAUTION: Air cooledenginesrunhotterthanautomotive _=ngines.The useof non-syntheticmulti-viscosityoils(5W30, 10W-30etc.)intemperaturesabove40°F willresultin nigherthannormaloilconsumption.When usinga multi/ iscosltyoil,checkoil levelmorefrequently. '*CAUTION:SAE 30oil,ifusedbelow40°F,willresultin lard startingandpoesibleengineboredamagedue to nadequatelubrication. 1. Refer to the chart above for proper grade of oil. 2. Use a high quality detergent oil classified =For service SF, SG,SH, SJ" or higher. 3. Do not use special additives. NOTE: Synthetic oil meeting ILSAC GF-2, API certification and API service symbol with "SJ/CF Energy Conserving" or higher is an acceptable oil at all temperatures. Use of synthetic off does not alter required oil change intervals. Filling Up Gasoline WARNING: Fillfuel tank outdoors or in well- ventilated area, away from sparks, open flames, pilot lights, heat and other ignition sources. NOTE: On a vehicle which has already been started and/or operated once immediately prior to thisgasoline fill-up, turn engine off and let cool at least two minutes before removing gas cap. 1. Remove gas tank cap and fill tank to approximately 1.5 inches below top of neck to allow for fuel expansion. Be careful not to overfill. 2. Replace cap on the gas tank and tighten to secure. If fuel spills on part of engine or vehicle, wait until it evaporates before startingengine. Type of Gasoline • Use clean, fresh, regular unleaded gasoline with minimum 85 octane rating. • Do not use gasoline mixed with methanol, or gasoline which has been stored for more than 30 days. Always purchase fuel in quantity that can be used up within30 days. Fresh fuel prevents gum from forming in the fuel system or on carburetor. • Do not mix gasoline with engine oil. NOTE: Some fuels, called oxygenated or reformulated gasoline, are blended with alcohols or ethers. Using these blends frequently can damage the fuel system or affect performance. If engine performance is affec...
Эта инструкция также подходит к моделям:Оборудование к ТС - 247 (2.91 mb)
Оборудование к ТС - 270 (2.91 mb)