Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
76
Dodatek B Předpisy a bezpečnostní upozornění
2
This equipment is not capable, under all operating conditions, of correct operation at
the higher speeds for which it is designed. Telecom will accept no responsibility should
difficulties arise in such circumstances.
3
Some parameters required for compliance with Telecom's Telepermit requirements
are dependent on the equipment (PC) associated with this device. The associated
equipment shall be set to operate within the following limits for compliance with
Telecom's Specifications:
eština
a
There shall be no more than 10 call attempts to the same number within any 30
Č
minute period for any single manual call initiation, and
b
The equipment shall go on-hook for a period of not less than 30 seconds
between the end of one attempt and the beginning of the next call attempt.
4
Some parameters required for compliance with Telecom's Telepermit requirements
are dependent on the equipment (PC) associated with this device. In order to operate
within the limits for compliance with Telecom's specifications, the associated
equipment shall be set to ensure that automatic calls to different numbers are spaced
such that there is not less than 5 seconds between the end of one call attempt and the
beginning of another.
5
This equipment shall not be set up to make automatic calls to Telecom's 111
Emergency Service.
For Modem with approval number PTC 211/01/030
1
The grant of a Telepermit for any item of terminal equipment indicates
only that Telecom has accepted that the item complies with minimum
conditions for connection to its network. It indicates no endorsement of
the product by Telecom, nor does it provide any sort of warranty.
Above all, it provides no assurance that any item will work correctly in
all respects with another item of Telepermitted equipment of a different
make or model, nor does it imply that any product is compatible with all
of Telecom's network services.
2
This equipment is not capable, under all operating conditions, of
correct operation at the higher speeds for which it is designed.
Telecom will accept no responsibility should difficulties arise in such
circumstances.
3
This device is equipped with pulse dialing while the Telecom standard
is DTMF tone dialing. There is no guarantee that Telecom lines will
always continue to support pulse dialing.
4
Use of pulse dialing, when this equipment is connected to the same
line as other equipment, may give rise to bell tinkle or noise and may
also cause a false answer condition. Should such problems occur, the
user should NOT contact the telecom Fault Service.
5
This equipment may not provide for the effective hand-over of a call to
another device connected to the same line.
...