Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Back to Contents Page 1 keyboard 2 keyboard tab (3) 3 keyboard cable 4 securing tab (2) NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the keyboard. Back to Contents Page Memory Module Dell™ Inspiron™ 910 Service Manual Removing the Memory Module Replacing the Memory Module You can increase your computer memory by replacing the current memory module on the system board with a higher one. See "Basic Specifications" in your Setup Guide for information on the memory supported by your computer. Install only memory modules that are intended for your computer. Your computer has a user-accessible SODIMM socket that can be accessed from the bottom of the computer. Removing the Memory Module The memory module is located at the bottom of the computer. 1. Follow the instructions in Before You Begin. 2. Remove the module cover (see Removing the Module Cover). 3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up. 4. Remove the memory module from the connector. Replacing the Memory Module 1. Follow the instructions in Before You Begin. 2. Align the notch in the memory module edge connector with the tab in the memory module connector slot. 3. Slide the memory module firmly into the slot at a 45-degree angle, and rotate the memory module down until it clicks into place. If the module does not click into place, remove the memory module and reinstall it. CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at NOTE: Memory modules purchased from Dell are covered under your computer warranty. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer). NOTICE: To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips. 1 memory module connector 2 securing clip (2) 3 memory module NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer). 4. Replace the module cover (see Replacing the Module Cover). 5. Slide the battery into the battery bay until it clicks into place and slide the battery-lock latch to the lock position. 6. Turn on the computer. As the computer boots, it detects the additional memory and automatically updates the system configuration information. To confirm the amount of memory installed in the computer: Windows® XP: Right-click the My Computer icon on your desktop, then click Properties® General. Ubuntu®: Click ® System® Administration® System Monitor. Back to Contents Page NOTE: If the memory module is not installed properly, the computer may not boot. No error message indicates this failure. 1 tab 2 notch NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer. Back to Contents Page Microphone Dell™ Inspiron™ 910 Service Manual Removing the Microphone Replacing the Microphone Removing the Microphone 1. Follow the instructions in Before You Begin. 2. Remove the module cover (see Removing the Module Cover). 3. Remove the keyboard (see Removing the Keyboard). 4. Remove the palm rest (see Removing the Palm Rest). 5. Disconnect the microphone cable from the system board. 6. Remove the microphone from the computer base. Replacing the Microphone 1. Insert the microphone in the slot and connect the microphone cable to the connector on the system board. 2. Replace the palm rest (see Replacing the Palm Rest). 3. Replace the keyboard (see Replacing the Keyboard). 4. Replace the module cover (see Replacing the Module Cover). 5. Slide the battery into the battery bay, until it clicks in place and slide the battery-lock latch towards the lock position. Back to Contents Page CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer). NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the computer. NOTE: The analog microphone is not present if you have ordered the optional camera. Instead, you will have digital array microphones with the camera. 1 microphone 2 microphone cable connector Back to Contents Page Communication Cards Dell™ Inspiro...