Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
Before installing anything, use the System Restore utility to set a restore point (see the section titled restore points). If anything goes wrong, you will then be able to easily restore the Windows® operating system to the state it was in prior to the installation, undoing any changes that the installation process introduced. . Back up your critical data (see “Backing up your data or your entire computer with the Windows® operating system” on page 187). . Have your factory Restore/Reconfiguration CD(s) on hand in case you need any files from them (available on certain models). If Something Goes Wrong If Something Goes Wrong Develop good computing habits . Do not guess—follow directions carefully! It is often necessary to run an installation utility first—before connecting a new hardware item to the computer. If the device is connected first, it may be very difficult to complete the installation successfully. Always carefully follow the installation instructions that accompany the hardware or software. . Restart the Windows® operating system. Always restart the Windows® operating system after each installation, even if the installation utility does not prompt you to do so. This will ensure that the installation is completed, and will clean up anything that the installation utility left behind. . Do one installation at a time. If you have several new items to add to your computer system, install just one at a time, creating restore points immediately before each successive installation. This will make it much easier to determine the origin of any new problems. For best results, follow this sequence: 1 Back up critical data. 2 Create a restore point. 3 Install one item of hardware or software. 4 Restart the Windows® operating system. 5 Use the new hardware or software for a while, noting any new problems. Make sure that your critical applications (email, business applications, etc.) are working correctly, and verify that important devices are still functioning. 6 For each additional hardware or software item, repeat these steps, starting at step 1 if any of your critical data has changed, or starting at step 2 if no critical data has changed. The eSATA device is not recognized from Sleep or Hibernation mode. A connected eSATA device may not be recognized if it is connected to the computer’s eSATA/USB combo port while the computer is in Sleep or Hibernation mode. If this occurs, disconnect the eSATA device and then reconnect the device while the computer is turned on. NOTE Before connecting the eSATA device to your computer and external power source, read the documentation that came with the device and follow the manufacturer’s instructions. If Something Goes Wrong If Something Goes Wrong If you need further assistance If you need further assistance If you have followed the recommendations in this chapter and are still having problems, you may need additional...
Эта инструкция также подходит к моделям:Ноутбуки - Satellite L500-ST2522 (4.04 mb)
Ноутбуки - Satellite L500-ST2543 (4.04 mb)
Ноутбуки - Satellite L500-ST2544 (4.04 mb)
Ноутбуки - Satellite L500-ST5505 (4.04 mb)