Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Page 5 Installation Instructions Step 3: Mount the eX.10’s display Twist the supplied round plastic plate to the base of the eX.10’s display, and attach the supplied double.sided tape to this plate. Clean the dash area where the eX.10’s display will be mounted with the supplied alcohol pad. Remove the backing from the double.sided tape, and attach it to the dash by pressing firmly*. Connect the monitor cable to the display base, and route the monitor cable to the desired location for the eX.10’s power supply using the supplied cable clamps *Note: There are many custom.mounting options for the eX.10’s display; refer to the Alpine Dealer Ad Center for a step.by.step tutorial showing how to build a custom A.pillar display mount. Page 6 Installation Instructions Step 4: Connect the eX.10 to 12 volt power Purchase a 12 volt accessory outlet with a female cigarette lighter plug, like this one from Radio Shack (Part #270.1556). Connect the accessory outlet’s power leads to a switched +12 volt accessory lead in the car, such as the factory cigarette lighter wiring. Screw the eX.10’s power cable into the cigarette lighter adapter. Plug the accessory outlet into the eX.10’s cigarette lighter adapter. Route the yellow end of the eX.10’s power cable to the desired location for the eX.10’s power supply. Page 7 Installation Instructions Step 5: Install the iPod cable Find a convenient, hidden location to place the customer’s iPod, such as the center console or the glove box. Route the supplied iPod cable to the desired location for the eX.10’s power supply. Page 8 Installation Instructions Step 6: Connect the eX.10’s power supply Plug the monitor cable into the port on the eX.10’s power supply marked “monitor”. Plug the iPod cable into the port marked “iPod”. Plug the “eX.10” output from the KWE.155B FM splitter into the “antenna” port (unless you are using the “AUX in” option) Plug the microphone cable into the “microphone” port. Screw the yellow end of the power cord into the port marked “power supply”. Mount the eX.10’s power supply in a hidden location. Page 9 Installation Instructions Step 7: Set up the eX.10 to work correctly Step 7a: Setting language and output mode Connect the eX.10’s display to the base by pushing down until you hear a “click”. Turn on the ignition to power up the eX.10. To select the desired language, push the “setup” button, then use the >>I button to scroll down to “general”. Tap “enter” twice, then select your language using the I<< and >>I buttons. Tap “enter” to select. You’re still in “setup” mode, so tap the >>I button three times until you get to “Output Mode”. Tap “enter”, and use the >>I button to select “Wire Transmitter” when using the KWE.155B antenna splitter, or “Aux” when using the eX.10’s auxiliary output. Now, tap the button to get back to the “ Setup” menu. Page 10 Installation Instructions Step 7: Set up the eX.10 to work correctly Note: When using “Option #1” (AUX input) skip step 7b Step 7b: Setting the FM trans...
Эта инструкция также подходит к моделям:Наушники и микрофоны - eX-10 (4.53 mb)