Оценок - 3, средний балл: 5
(
)
)
|
Фрагмент инструкции
NOTE: The instructions in this manual are for the use of qualified individuals specially trained and experienced in the installation and maintenance of this type of equipment and related system components. Installation and service personnel are required by some states to be licensed. Persons not qualified shall not attempt to install, service, or maintain this equipment. This manual should be maintained in legible condition and kept adjacent to the heat pump pool heater or in a safe place for future use. Catalog No. 6000.551A Effective: 04-10-09 Replaces: 04-02-09 P/N 241363 Rev. 2 2 Water Chemistry (Corrosive water voids all warranties) For your health and the protection of your pool equipment, it is essential that your water be chemically balanced. The following levels must be used as a guide for balanced water. Recommended Level(s) Fiberglass Pools Fiberglass Spas Other Pool & Spa Types Water Temp. (Deg. F) 68 to 88 89 to 104 68 to 104 pH 7.3 to 7.4 7.3 to 7.4 7.6 to 7.8 Total Alkalinity (PPM) 120 to 150 120 to 150 80 to 120 Calcium Hardness (PPM) 200 to 300 150 to 200 200 to 400 Salt (PPM) 6000 MAXIMUM 6000 MAXIMUM 6000 MAXIMUM Free Chlorine (PPM)* 2 to 3 2 to 3 2 to 3 Total Dissolved Solids (PPM) 3000 MAXIMUM 3000 MAXIMUM 3000 MAXIMUM *Free Chlorine MUST NOT EXCEED 5 PPM! • Occasional chemical shock dosing of the pool or spa water should not damage the heater providing the water is balanced. • Automatic chemical dosing devices and salt chlorinators are usually more efficient in heated water. Unless controlled, they can lead to excessive chlorine level which can damage your heater. • Further advice should be obtained from your pool or spa builder, accredited pool shop, or chemical supplier for the correct levels for your water. 3 CONTENTS Water Chemistry Warnings Pay Attention to These Terms Introduction Installation Considerations Electrical Connections Water Connections Pressure Drop Controls & Indicator Lamps (Analog Models) System Start-Up Controls (Digital Models) Digital Controls Operating Instructions To Select Pool or Spa Mode To Increase the Desired Water Temperature (Pool or Spa Mode) To Lower Desired Water Temperature (Pool or Spa Mode) To Select Temperature in °C or °F System Start-Up Seasonal Start-Up or Annual Check Summer Shutdown Freeze Protection System Drain-Down Continuous Pump Operation 3 Maintenance 13 5 Air Coil Cleaning 13 5 Cabinet Care (optional) 13 6 Unplug Condensation Drain Holes 13 6 Troubleshooting 14 7 Service Call Verification 15 9 Power Supply 15 9 Water Flow 15 Time Clock Adjustment 15 10 Plumbing Diagrams 16 11 Wiring Diagram — 208V/230V 11 Single-Phase — Analog Models 18 Wiring Diagram — 208V/230V 12 Single-Phase — Digital Models 19 12 Wiring Diagram — 208V/230V 3-Phase — Analog Models 20 12 Wiring Diagram — 208V/230V 3-Phase — Digital Models 21 12 Installing a Remote Control 12 Device on Analog Heaters 22 12 Wiring 22 Heater Settings 22 12 Installing a Remote Control 13 Device on Digital Heaters 22 13 Wiring 22 13 Heater Settings 22 13 4 Warnings — Pay Attention to These Terms DANGER: Indicates the presence of immediate hazards which will cause severe personal injury, death or substantial property damage if ignored. WARNING: Indicates the presence of hazards or unsafe practices which could cause severe personal injury, death or substantial property damage if ignored. CAUTION: Indicates the presence of hazards or unsafe practices which could cause minor personal injury or product or property damage if ignored. NOTE: Indicates special instructions on installation, operation, or maintenance which are important but not related to personal injury hazards. This manual, as well as the pool/spa heat pump pool heater itself, contains ANSI-approved product safety signs and labels. Please read these signs and labels, as they convey important safety information about hazards that may be potentially present in and around the heat pump pool heater. CAUTION: Elevated water temperature can be CAUTION: Improper chemical content in a swim- hazardous. The U.S. Consumer Product Safety ming pool or spa can damage the heat pump pool Commission has these guidelines: heater. DO NOT add pool chemicals to the skimmer. This will damage the heat pump pool heater and 1. Spa water temperatures should never exceed could void the heat pump pool heater warranty. 104°F (40°C). A temperature of 100°F (38°C) is ALWAYS follow the product manufacturer’s direcconsidered safe for a healthy adult. Special cautions when adding any chemicals to your pool. tion is suggested for young children. 2. Drinking of alcoholic beverages before or during spa or hot tub use can cause drowsiness which could lead to unconsciousness and subsequently result in drowning. 3. Pregnant Women Beware! Soaking in water over 102°F (39°C) can cause fetal damage during the first three months of pregnancy resulting in the birth of a brain-damaged or deformed child. Pregnant women should stick to the 100°F (38°C) maximum rule. 4. Before...
Эта инструкция также подходит к моделям:Насосное оборудование - POOL & SPA 5310 (1.08 mb)
Насосное оборудование - POOL & SPA 8320 (1.08 mb)