Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
10. Delay/Reverb: This switch selects between Delay or Reverb effects. Press switch in to choose Delay. 11. Effects: This control increases the effect signal level and mixes it with the instrument’s signal. Turn this control clockwise to add the desired level of effects. 12. Chorus: By pressing in, this switch activates a lush Chorus effect. (Note: When Chorus is activated, it is always mixed with either Delay or Reverb, as selected by the Delay/Reverb switch.) 13. Aux In: This is a 3-conductor, 1/8-inch, stereo jack that allows playback from a Compact Disc, MP3 player or other audio device. The overall volume level will be determined by the audio device, so start with lower volume levels and increase as needed. 14. Headphones: This is a 3-conductor, 1/8-inch jack intended for headphone use. Speaker cabinets will remain active when using headphones. For silent practice, speaker cabinets may be disconnected from the head. 15. Power Switch: This dual-function component is both an On/Off power switch and a status indicator light. When illuminated, it shows that your amplifier is ready to be played. To turn amplifier on, press switch upward. To turn amp off, press switch downward. kustom.com kustom.com Speaker Output: This is a 1/4-inch speaker jack that is used to connect the KG100HFX to a speaker cabinet. Rating is 4-ohms minimum. For full power, use a 4-ohm load. (The Kustom KG412 speaker cabinet is the ideal match for the KG100HFX both in terms of impedance and tonality.) Footswitch: This .-inch jack is used to connect an optional footswitch to the amplifier. The Kustom model KACFS- 100 may be purchased separately. This single-button footswitch can be used to select between the Lead and Rhythm channels while playing. Effects Loop Send: Use this 2-conductor, .-inch jack to connect to the input of an external effects processor or equalizer. This jack can also be used as a Preamp Out. Effects Loop Return: Use this 2-conductor, .-inch jack to connect to the output of an external effects processor or equalizer. This jack can also be used as a Power Amp In. (Note: This jack separates the preamp from the power amp. If using an external effect, the effect will be in series between the Effects Loop Send and Effects Loop Return. The amount of “dry” signal will be controlled by the external effect.) 1. AC Power Cord Receptacle: AC power cord can be removed for easy storage and replacement if damaged. Insert the AC cord (provided) firmly into the AC receptacle. NOTE: Replace the AC power cord if protective jacket is damaged or ground pin is damaged or removed. 2. Fuse: The fuse is located in a fuse tray just below the receptacle. Replace only with the same type and size. For your convenience, a spare fuse is located inside the fuse tray toward the front. To replace fuse, remove AC power cord. Remove fuse tray by pulling the tab located above the fuse symbol away from the receptacle. KG100HFX Back Panel KG100HFX AC Mains KG100HFX Suggested Settings The following suggested settings will help you dial in a variety of popular tones. Keep in mind, these are starting points to get you up and running with your KG amplifier. Feel free to experiment to achieve your own signature sounds. CLEAN GUITAR These settings are for punchy clean tones that are commonly used in Pop, Country, Alternative and many other genres of music. Use the Rhythm channel with the tone controls set to emphasize brighter sounds. The Bass control should be adjusted to maintain the clarity of the overall tone. Add Reverb and Chorus as desired. MEDIUM-GAIN GUITAR These settings are appropriate for Rock, Blues or other music styles that require a moderate amount of distortion. Use the Lead channel with the Gain set to its middle ranges. Likewise, keep the Mid control in its middle ranges but increase the amount of Treble to maintain clarity. HIGH-GAIN GUITAR Try these setting ranges when you want to produce the heaviest tones. Notice that the Gain control is cranked up, the amount of Bass is increased and Midrange is reduced for a heavy, modern vibe. Experiment by adding a bit of Delay to high-gain solos. kustom.com Kustom® KG100HFX Specifications Output Power 100 Watts RMS 4 Ohms at 5% THD Input Impedance 470K Hum & Noise -56dB Residual noise, all level controls 0% (minimum) Lead Gain 96 dB Lead Gain and Volume controls full 70 dB Lead Gain and Volume controls half way Clean Gain 60 dB Clean volume control full 45 dB Clean volume control halfway Nominal Signal to Noise 75 dB Volumes and Gain halfway Footswitch Channel Select Kustom “”KAC-FS100”” recommended, but any single button alternate contact LED or Non LED type OK. Effects 4 selectable digital effects Reverb, Delay, Chorus/Reverb, Chorus/ Delay Power Requirements USA/Canada 120VAC/60Hz, 180W Europe 230VAC/50Hz, 180W UK 230VAC/50Hz, 180W Australia 240VAC/50Hz, 180W Japan 100VAC/50-60Hz, 180W Dimensions/Weight mm/Kilogram 235 (Height) X 582 (Width) X 240 (Depth), 10 Kilogram Inches/Pounds 9.3 (Height) X ...