Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
bo - Boutique Wah is a wider sweeping Wah with a more modern sound. Fr - Full Range Wah sweeps the entire spectrum of audible frequencies. Compressor A Compressor is used to automatically limit the dynamic level of the guitar signal. 1 to 15 - Controls the amount of compression (ratio and sustain) and ranges from 1 (slight compression) through infinity (maximum sustain) or turns the compression effect off. Amp/Cabinet Modeling Amp Modeling is a technology that applies the tones of several popular modern and vintage amps and acoustic guitar simulation. Values 1-9 increase the amp’s gain and level. b1-b9 - Based on a Blackface c1-c9 - Based on a Clean Tube amp o1-o9 - Based on Boutique s1-s9 - Based on a British Stack r1-r9 - Based on a Rectifier U1-U9 - A nice crunchy tube combo H1-h9 - Based on a Hot Rod G1-g9 - Based on High Gain tube amp t1-t9 - Based on a Classic Tweed F1-f9 - A vintage fuzz distortion C1-C9 - Based on a British Combo AC - A flat top acoustic guitar Any trademarks are the property of their respective companies and are in no way associated with DigiTech. EQ Equalization is used to shape the tonal response of your guitar signal. The EQ in the RP80 is similar to the tone knobs on an amplifier. Values 1-4 cut the level of each band, 5 is flat (no cut or boost), and values 6-9 boost the level of each band. Bass (b1-b9 ) - The Value buttons adjust the amount of low end enhancement (Bass). Mid (d1-d9)- The Value buttons adjust the amount of mid range enhancement. Treble (t1-t9)- The Value buttons adjust the amount of high end enhancement (Treble). Noise Gate A Noise Gate is designed to eliminate noise while you are not playing. The AutoSwell setting creates a volume pedal effect automatically with varying attack times. Different guitars and pickups require different threshold settings. Choose a setting that fully mutes the sound when you are not playing for the lowest setting. Of. G1-G9 - Selects the Silencer™ Noise Gate. Settings 1-9 select the threshold. Of turns the gate effect off. s1-s9 - Selects the Auto Swell volume swell effect. Settings 1-9 select the attack time. Chorus/Mod The Chorus/Mod module is a multi-function module that lets you select the following effects:Chorus,Flanger,Phaser,Tremolo,Panner,Vibrato,Rotary Speaker, YaYa™,AutoYa™, Envelope, Detune, Pitch Shift, and Whammy™ effects. When the Chorus/Mod module is selected, the Value buttons are used to choose the type of effect. Only one of the effects in this row can be used at a time. The following list describes each effect and their parameters in more detail. Chorus (C1-C9) A Chorus adds a short delay to your signal. The delayed signal is modulated in and out of tune and then mixed back with the original signal to create a thicker sound, and stereo image. Use the Value buttons to select one of the nine Chorus settings. Flange (F1-f9) A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds regeneration (or repeats) to the modulating delay. This results in an exaggerated up and down sweeping motion to the effect. Use the Value buttons to select one of the nine Flanger settings. Phaser (P1-p9) A phaser splits the incoming signal, and changes the phasing of the signal. The signal is taken in and out of phase and mixed back in with the original signal. As the phasing changes, different frequencies get canceled resulting in a warm sort of twisting sound. Use the Value buttons to select one of the nine Phaser settings. Tremolo (t1-t9) A Tremolo effect modulates the volume of the signal at an even rate. Use the Value buttons to select one of the nine predetermined settings. Panner (n1-n9) An Auto Panner modulates the sound from left to right at an even rate. Use the Value buttons to select one of the nine Panner settings. Vibrato (b1-b9) A Vibrato effect modulates the pitch of the incoming signal at an even rate. Use the Value buttons to select one of the nine Vibrato settings. Rotary Speaker (r1-r9) Rotary Speaker is an emulation of a device that included a spinning horn and woofer. The rotation of these two speakers produces an interesting combination of sound panning from side to side with a slight pitch change produced from the speed of the sound coming towards, and then going away from the listener. Use the Value buttons to select one of the nine Rotary Speaker settings. YaYa™ (y1-y9) The YaYa™ is another effect exclusive to DigiTech products. Like the AutoYa™, it combines the characteristics of a wah and a flanger together providing a unique talk box type of effect, but is controlled by the Expression Pedal. AutoYa™ (a1-a9) An AutoYa™ combines the characteristics of a Wah and a Flanger together creating an almost human vowel characteristic as if the guitar were saying “Yah.” The AutoYa™ provides animation to the sound based on string attack. Use the Value buttons to select one of the nine AutoYa™ settings. Envelope Filter (E1-e9) The Envelope Filter is a dynamic Wah effect that alters your sound ba...