Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
Connect the Preamp Output, using a shielded cable, to an input of the tape recorder, mixer, etc. This patch does not affect the operation of the amplifier. NOTE: The preamp output level is approximately 1 volt RMS and is of relatively low impedance (600 ohms). Any effects device used in this effects loop must be capable of receiving 1 volt input and providing 1 volt output in order to properly drive the power amp. The Power Amp Input has an internal switch which disconnects the internal preamp. MASTER REVERB (13) Determines the overall effects level supplied to the internal reverb unit. POWER LED (14) Illuminates when AC power is being supplied to the amp. GROUND SWITCH (15) Three position rocker-type switch which, in most applications, should be operated in its center or zero position. There may be some situations when audible hum and/or noise will come from the loudspeaker. If this situation arises, position the ground switch to either positive or negative ( + or -) or until the noise is minimized. NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or a qualified service technician. THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT MODELS. POWER SWITCH (16) Depress the switch to the “On” position. The red pilot light (LED) will illuminate indicating power is being supplied to the unit. 17 18 t?0 VAC 60 Hi tso WAITS BUfcT UNDER US PATENT NO * J'8053 + WARNING TOMEVtN' !l< FIS* AAOS-CCK iWA»V X> MCI cXPOSi TK-S APPl'ANCf TO RAIN <>» — wxsrmil 00 W! WVCvEFBOMCASl NOlrttH StiverAflli »AMtSriSCF RE=fcRSir
Музыкальные инструменты - KB 60 (3.8 mb)