Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
This signal would not be assigned to any output on the house console, merely CUE'd for headphone monitoring by the engineer. The house soundman sends his TB signal via his foldback output to an input channel on the mixer. The monitor engineer would then cue the input channel for monitoring in his headphones. (ALTERNATIVE DIRECT CONNECTION) TALKBACK-PHONES— -AUX OUT -RETURN P.A. MIXING CONSOLE (e.g. YAMAHA MC3204II) RETURN-TB OUT- PHONES TALK BACK MC3210M, MC2410M 14 SPECIFICATIONS GENERAL SPECIFICATIONS FREQUENCY RESPONSE 20 Hz —20 kHz+1/-3 dB (@600 0, +4 dB) TOTAL HARMONIC DISTORTION <0.1% (20 Hz —20 kHz) @+14 dB output into 600 £2 NOISE LEVELS*1 Equivalent input noise -128 dB (Rs = 150 £2) Residual output noise -97 dB (balanced output) MAXIMUM VOLTAGE GAIN CH IN h» GROUP OUT (1 — 8.9/L.10/R) 80 dB CH IN AUX OUT 76 dB CH IN ->CH INSERT OUT 60 dB RETURN —> GROUP OUT (1 — 8,9/L,10/R) 16 dB TALKBACK IN GROUP OUT (1 — 8,9/L,10/R) 70 dB SUB IN -> GROUP OUT (1 — 8,9/L,10/R) 10 dB SUB IN -s. AUX OUT 6 dB CUE SUB IN —> CUE OUT 6 dB Input gain control 44 dB variable Input phase switch normal / reverse Input PAD switch 20 dB EQUALIZER CHARACTERISTICS Max. variable range ±15 dB HIGH 10 kHz*2 shelving HIGH-MID 400 Hz — 8 kHz peaking LOW-MID 80 Hz — 1.6 kHz peaking LOW 100 Hz*2 shelving Input High Pass Filter 12dB/octave roll-off 80 Hz CROSSTALK -70 dB @ 1 kHz, adjacent input -70 dB @ 1 kHz, Input to output CH Peak Indicator CH Peak LED turns on when post-EQ signal is-above the level 3 dB lower than clipping level. Cue Signal Indicator Cue Signal LED turns on when cue signal is above the level 20 dB lower than nominal level. VU Meters (0 dB=+4 dB output) 12 illuminated meters with Peak indicators turn on when output signal Is above the level 3 dB lower than clipping level. Phantom Power +48 (DC) is applied to balanced inputs for powering condenser microphones. POWER REQUIREMENTS (Usable voltage range) US & Canadian models 120 V, 60Hz General model 230 V, 50 Hz POWER CONSUMPTION 80 W DIMENSIONS (W x H x D) MC 2410M 1204 x 185 x 739 mm (47.4" x 7.3" x 29.1") MC 3210M 1485 x 185 x 739 mm (58.5" x 7.3" x 29.1") WEIGHT MC2410M 38 kg (84 lbs.) MC3210M 46 kg (102 lbs.) *1 20— 20 kHz (average) Input Gain MAX, Input PAD SW off-input sensitivity= -60 dB *2 Turnover/roll-off frequency: 3 dB below maximum variable level • 0 dB = 0.775 Vr.m.s. SERVICE The MC2410M/MC3210M are supported by Yamaha's worldwide network of factory trained and qualified and dealer service personnel. In the event of a problem, contact your nearest Yamaha dealer. 16 INPUT/OUTPUT SPECIFICATIONS INPUTS Input Terminals Actual Load Impedance For Use with ■Nominal Sensitivity*1 Input levels Connector in Mixer PAD GAIN TRIM Nominal Maximum non-cliping level CH-INPUT MC2410M 1—24 MC3210M 1—32 OFF (0 dB) -60 dB (LO-Z) 5 kO (Hl-Z) 10k0 50—600 0 Microphones or 600 O Lines -76 dB (0.12 mV) -60 dB (0.78 mV) -40 dB (7.75 mV) (LO-Z) XLR-3-31type (Balanced) (Hl-Z) Phone Jack (TRS)*2 16 dB -32 dB (19.5 mV) -16 dB (0.123 V) +4 dB (1.23 V) ON (20 dB) -12 dB (0.195 V) +4 dB (1.23 V) +24 dB (12.3 V) ,^r,-r , MC2410M1—24 INSERT INCH M0321OM1—32 10 kO 600 O Lines -16 dB (0.123 V) 0 dB (0.775 V) +20 dB (7.75 V) Phone Jack (TRS)*3 INSERT IN GROUP (1 — 8,9/L,10/R) 10k0 600 O Lines -10 dB (0.245 V) 0 dB (0.775 V) +20 dB (7.75 V) Phone Jack (TRS)*3 RETURN (1,2,3,4) 20 kii 600 O Lines -12 dB (0.195 V) +4 dB (1.23 V) +24 dB (12.3 V) Phone Jack (Unbalanced) SUB GROUP (1 — 8,9/L,10/R) IN AUX (1,2) CUE (L,R) 10 kO 600 O Lines -6 dB (0.388 V) +4 dB (1.23 V) +24 dB (12.3 V) Phone Jack (Unbalanced) TALKBACK IN 10 kO 50 — 600 0 Microphones -66 dB (0.39 mV) -50 dB (2.45 mV) -24 dB (48.9 mV) XLR-3-31 Type (Unbalanced) *1) Sensitivity is the lowest level that will produce the nominal GROUP output level when the unit ¡s set to maximum level. *2) Hl-Z INPUT Jacks (T=HOT, R=COLD, S=GND) *3) Insert Phone Jacks (T=OUT, R=IN, S=GND) • 0 dB is referenced to 0.775 Vrms. OUTPUTS Output Terminals Actual Source Impedance For Use with Nominal Output Level Connector in Mixer Nominal Max. before clip GROUP OUT (1 -8,9/L, 10/R) 150 0 600 O Lines +4 dB (1.23 V) +24 dB (12.3 V) XLR-3-32 Type (Balanced) AUX OUT(1,2) 75 0 600 O Lines +4 dB (1.23 V) +20 dB (7.75 V) Phone Jack (Unbalanced) TALKBACK OUT 75 0 600 O Lines +4 dB (1.23 V) +20 dB (7.75 V) Phone Jack (Unbalanced) CUE OUT (L,R) 75 0 600 O Lines +4 dB (1.23 V) +20 dB (7.75 V) Phone Jack (Unbalanced) MC2410M 1-24 INSERT OUT CH MC32ioM1~32 600 0 10 kO Lines 0 dB (0.775 V) +20 dB (7.75 V) Phone Jack (TRS)*1 INSERT OUT GROUP (1-8,9/L, 10/R) 600 0 10 kO Lines 0 dB (0.775 V) +20 dB (7.75 V) Phone Jack (TRS)*1 PHONES OUT (L,R) 100 O 8 O Phones 1 mW 20 mW Stereo Phone Jack 40 O Phones 3 mW 75 mW *1) Insert Phone Jacks (T=OUT, R=IN, S=GND) • 0 dB is referenced to 0.775 Vrms. 17 YAMAHA CONSOLES DE MIXAGE MCS41GM MC BEIOM MANUEL D...
Эта инструкция также подходит к моделям:Музыкальные инструменты - MC3210M (3.26 mb)