Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
All AUX controls are “post-EQ/post-fader,” meaning that their signal is derived from a point after the channel EQ stage and fader. This means that the AUX signal is affected by the channel EQ and fader settings. 0 PAN Control The PAN controls assign the signal from the corresponding channel to any desired position in the "stereo sound field.” If a PAN control is set to the maximum “L” (LEFT) position, the signal from that channel will appear only at the left-channel output (ST OUT L). If the PAN control is set fully “FT (RIGHT), the signal will appear only at the ST OUT R output jack. If a PAN control is set to its center position, then the signal from that channel will appear equally at both the left- and right-channel outputs, and the sound will appear at the center of the stereo sound field (at a point midway between the two stereo speakers). Other PAN control settings place the sound at positions roughly corresponding to the PAN control setting by varying the level of the signal sent to the left- and right-channel outputs. : - : LEFT RIGHT “ SPEAKER SPEAKER \l/ \l/ /|\ \l/ 0 Channel Fader This is the main level control for each input channel. It determines the level of the signal sent from the corresponding input channel to the master stereo buss. The settings of the input channel faders determines the “mix” or balance of sound levels between the instruments or other sources connected to the inputs. NOTE: -- If a channel is not being used, its fader should be set to the minimum position to prevent unwanted noise from being added to the main program signals. -3 - • Master Control Section O AUX SND Controls These adjust the overall output level of the AUX 1 and AUX 2 “mixes” set up using the corresponding channel AUX controls. AUX SND 1 sets the overall level of the AUX 1 mix signal appearing at the AUX SND 1 jack, and AUX SND 2 sets the overall level of the AUX 2 mix signal appearing at the AUX SND 2 jack. These controls should be used to optimally match the AUX SND output level of the mixer to the input sensitivity of the external signal processing device or power amplifier used. O AUX RTN Controls These controls adjust the level of the signal received at the corresponding rear-panel AUX RTN jacks and mixed into the main program on the master stereo buss. Stereo inputs are provided for each AUX RTN input, providing compatibility with the many mono-in/ stereo-out signal processors currently available. 0 MASTER Fader The MASTER fader controls the master output levels of both the left and right channels, and thus the level of the signals appearing at the ST OUT L and R jacks.