Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
¦ Using the NS-M125 as Normal Stereo Speakers To get the best stereo performance, angle the speakers inward so as to create a triangle, with the listener at the apex. ¦ Using the NS-M125 as Front Speakers in a Surround Sound System Position the speakers both side of your TV. The positioning of these speakers is important because they provide a solid anchor for the sound image. They should be positioned facing the listener at about ear level, and equidistant from the TV. Subwoofer Center Front L Front R Surround L Surround R ¦ ¦ speakers in a surround sound shown in the figure below, and hang the holes on the protruding screws. system English The speakers can be mounted on a wall by using the bracket attached to the speakers’ back panels. Holes Make sure that the screws are caught by a narrow part of the holes securely. 26 mm (1”) NS-M125 Wall or wall support Tapping screw (commercially available) Diam. 3.5 to 4 mm (1/8”) 3 mm (1/8”) Min. 20 mm (3/4”) WARNING: • Each speaker weights 2 kg (4.4 lbs). Do not mount them on thin plywood or soft wall surface material, as the screws may come out of the flimsy surface, causing the speakers to fall down and be damaged, or result in personal injury. • Do not fasten the speakers to wall with nails, adhesives, or other unsound hardware. Long term use and vibrations may cause them to fall down. • To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall. Note: You can also use the screw holes on the bottom of the NS-M125 for installing the speakers on commercially available speaker stands. A screw with a diameter of 6 mm (3/16”) can be used (Hole depth: 14 mm, 7/16”) 60 mm (2- 3/8”) • Before installing, please refer to the instruction manual of the speaker stand. E-3 ¦ ¦ Place the speaker on the floor under the TV or inside the TV rack so that it is stabilized. ¦ Mounting the center speaker NS-C125 on the wall The speaker can be mounted on a wall by using the bracket attached to the speaker’s back panel. When placing the speaker on top of the TV To prevent the speaker from falling down, put the provided fasteners at two points on both bottom of the speaker and top of the TV. Holes 12Peel off the seal TV set Fastener NS-C125 NS-C125 Notes: • Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. Wall or wall support Tapping screw (commercially available) Diam. 3.5 to 4 mm (1/8”) 3 mm (1/8”) Min. 20 mm (3/4”) Make sure that the screws are caught by a narrow part of the holes securely. 292 mm (11-1/2”) Fasten screws into a firm wall or wall support as shown in the figure below, and hang the holes on the protruding screws. If placed, the speaker may drop out causing an injury to you. • Do not place the speaker on top of the TV with an inclination. • Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. • Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is ...