Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate sheet). These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, this manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference. As shipped, the TU-12BW’s batteries are not yet installed. Be sure to read the section “Changing the Batteries,“ and then follow the instructions to install the batteries. Copyright © 2008 BOSS CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of BOSS CORPORATION. fig.01?????? .. Normal Tuning (AUTO CHROMATIC Mode) 1. Connect the plug of the included piezo mic to the INPUT jack and mount the piezo mic on the instrument you want to tune. To carry out tuning using the built-in microphone, connect nothing to the INPUT jack and place the TU-12BW close to the instrument. If you have a digital wind controller or an instrument with a built-in mic or pickup, plug its output into the INPUT jack. 2. Press [POWER] to switch the power on. 3. Press [AUTO/MANUAL] to enable the "AUTO" setting (lighting the green indicator). In AUTO CHROMATIC Mode, the TU-12BW automatically displays a note's pitch (the note name) as you play it on the instrument. Most of the time, AUTO is the most convenient mode to use. When you want to practice producing a specific pitch, you may want to use MANUAL mode; in this mode, only the pitch that you specify is detected and displayed. 4. Play a single note on the instrument. While the note is sounding, the name for the note's current pitch is displayed. The meter and Tuning Guide show how far the note is from the correct pitch. 5. Tune the instrument. With the intended note name displayed, tune the instrument so that and on the Tuning Guide light simultaneously and the meter's needle points to 0 (the center position). When the Accu-Pitch feature is on, the tuner makes a beeping sound when the note is stabilized at the correct pitch, informing you that the note is in tune. .. Training for a Specific Pitch (Tuning in MANUAL Mode) 1. Connect the plug of the included piezo mic to the INPUT jack and mount the piezo mic on the instrument you want to tune. To carry out tuning using the built-in microphone, connect nothing to the INPUT jack and place the TU-12BW close to the instrument. If you have a digital wind controller or an instrument with a built-in mic or pickup, plug its output into the INPUT jack. 2. Press [POWER] to switch the power on. 3. Press [AUTO/MANUAL] to enable the "MANUAL" setting (lighting the red indicator). 4. Press [ ] or [ ] to display the note name for the specific pitch you want to practice and/or tune. 5. Play ...
Эта инструкция также подходит к моделям:Ресиверы и усилители - TU-12BW (1.73 mb)