Войти:
Оценок - 3, средний балл: 4.3 ( )

Инструкция по эксплуатации Roland, модель OD-2R

Производитель: Roland
Размер: 155.65 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Power is turned on whenever a plug is inserted into the INPUT jack, and is turned off when the plug is disconnected. When not using the unit, you should disconnect any cord connected to the INPUT jack. 7. REMOTE Jack Connect an optional BOSS footswitch (FS-5L) to this jack and you can switch the TURBO effect on and off using the pedal. * When using the pedal to turn the TURBO effect on and off, set the TURBO Switch on the panel to *ON (REMOTE)". LEVEL Knob TONE Knob TURBO Switch LEVEL Knob This knob adjusts the level of the effect sounds. Set the knob so there is no volume difference between the effect and straight guitar sounds. * When this knob is rotated completely counterclockwise, no sound is heard. 6 TONE Knob This knob controls the tone of the distortion sounds; rotati ng the knob clockwi se boosts h igher frequencies, while rotating it counterclockwise cuts higher frequencies. DRIVE Knob This knob adjusts the depth of the distortion sounds; rotating the knob clockwise makes the distortion deeper and the sustain longer. TURBO Switch This switch turns the TURBO effect on and off. TURBO On : The overdrive sounds are ful! and powerful. TURBO Off: Just a hint of overdrive is present, creating sounds with a si ight edge. *Tbe TURBO effect can be turned on and off via foot control when an optional pedal switch is connected to the REMOTEjack. When using a pedal to turn the TURBO effect on and off, set the TURBO Switch on the panel to the "ON (REMOTE)''position. MAKING THE CONNECTIONS * inserting a plug into the Input jack will automatically switch the unit on. * Before connecting or disconnecting any patch cords, be sure all the volume controls in your system are set to minimum. This will help prevent any damage to system components. OPERATING THE UNIT 1 .When you have made the 2.Depress the pedal switch necessary connections, to turn the effect on. {Make sure (hat the CHECK indicator lights.) set the knobs of the unit as shown in the illustration. 3.Turn the TURBO effect on/off with the TURBO Switch. 4.Adjust the overdrive depth with the DRIVE Knob. CHECX MoaoTdl o LEVEL TONE drive on ooo • • • • 0 MM HU ID N1 m HU TUHBO CHANGING THE BATTERY When the indicator goes dim or no longer lights while an effect is on, it means that the battery is nearly dead and must be replaced. Replace the battery following the steps below. Thumbscrew — Ptdai ------SpririR Base H,ilti?ry Sn.ip CohJ ---------Coil Spring *)V H


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории