Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
The metronome will play from the first beat in the set Tempo, Beat and Rhythm. Pushing the same button will stop playing. * The first beat number will sound at the higher pitch than the others. When the ji , jjj or is selected, the first note of the first beat number will sound the highest and the other notes low. The first note of the succeeding beat numbers will sound at the medium pitch, and the other notes low. DISPLAY WINDOW In the Tuner mode, this indicates the selected Note Name. This indicates the selected Mode. This counts the selected Beat Number in the Metronome/Tap mode. This indicates the selected Beat in the Metronome/Tap mode. This indicates a different element depending on the mode currently in use. This indicates the selected Rhythm. ■ Using the DB-11 as Stopwatch ■ 0 Press the Mode Button intermittently until the Stopwatch indication "•*" flashes. @ Push the Start/Stop Button, and the colon ":" will flash every second. Now, the DB-11 is ready for timing. TAP START STOP Battery Replacement When the battery voltage drops, speaker output prevent this replace the battery. Use two manganese lithium batteries CR2032 3V's. © Loosen the screw on the bottom case, and remove the bottom case from the upper case. @ Press and rotate the battery holder a quarter circle in the direction shown by the arrows in the picture, and remove it from the battery box, then take the batteries out. ® Replace with a new set of batteries in correct polarity. Then return the battery holder. 0 Attach the bottom case to the upper case without catching the leads and tighten the screw. * Please do not touch the parts irrelevant to battery replacement. (3) To stop timing, push the Start/Stop Button. The time shown in the Display also stops. * As you repeat starting and stopping by pushing the Start/Stop Button, the Display will show the total time so far. TAP START STOP becomes low or the LED's light dimmer. To placing the batteries. In such a case, try pushing the Reset Button on the panel. © Pushing the Up or Down button will reset the Display to zero. * The maximum time display is 59 minutes 59 seconds 99. If the time exceeds that, it will be automatically reset to zero, then continue. * If you have not stopped timing at all (by pushing the Start/Stop Button) since you started timing, pushing the Up or Down Button has no effect for Display resetting. * If you touch the Mode Button during timing, the timing will stop and the Stopwatch mode is chagned to other mode. RESET BUTTON Press this button when the Display Window responds wrongly. This will always return the display to the default value, for instance, " " in the Metronome mode. * The setting you have made before pressing this button will be erased and the default setting will return. That is, you need to make the settings again. IMPORTANT NOTES Location • Avoid using the DB-11 in excessive heat or humidity or where it may be affected by direct sunlight or dust. Liquid Crystal Display • View the Display from the proper angle. • Please be careful not to damage the window. Cleaning • Use a soft cloth and clean only with a mild detergent. Do not use solvents such as painting thinner. NOTE When the uhit is turned on immediately after turned off, the Display may not show anything at all. If this happens, turn the unit off, then turn it on again in a few seconds. To avoid waste of batteries, be sure to turn the unit off when it is not in use. [MiRoland® 02459201 UPC 02459201 10981...