Оценок - 4, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
However, the speaker and RECORDING OUT/PHONES output is monaural. * Determine the volume level by adjusting the volume control of the connected device. * The Power Squeezer function is also applied to sounds input from the AUX IN jack. 11. RECORDING OUT/PHONES Jack When Using RECORDING OUT Use mono 1/4" phone plugs when connecting to this jack. Volume level of RECORDING OUT can be easily adjusted if you set the CLEAN or LEAD Channel VOLUME knob as shown in the diagram on the right. When Using Headphones Connect headphones to this jack. * No sound is played through the unit's speaker while the RECORDING OUT/PHONES jack is in use. 12. POWER SQUEEZER Switch Switching on the Power Squeezer function allows you to reduce the amp's output to 2 watts. Switching this on allows you to produce a sound that preserves the same tone and balance as when the amp is played at maximum volume, but at an output of 2 watts, for volume levels that are more suitable for the average home. 13.POWER Switch This switches the power on and off. * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally. * If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from the power outlet. Refer to “Power Supply" (p. 5). 6 Connections Refer to the figure shown below to connect the CUBE-15X to other equipment. Recorder CD/MP3 player Efl рУэрня о IP Electric Guitar Switching the Power On and Off Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. 1. Make sure that all volume controls on the CUBE-15X and connected devices are set to 0. ^ Main Specifications 2. Turn on all the devices connected to the CUBE-15X 's input jacks (INPUT jack and AUX IN jack). 3. Turn on the CUBE-15X. 4. Switch on any equipment connected to the CUBE-15X's RECORDING OUT/PHONES jack. 5. Adjust the volume levels for the devices. 6. Before switching off the power, lower the volume on each of the devices in your system and then TURN OFF the devices in the reverse order to which they were switched on. * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally. For protection from sudden big sound, always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear some sound when the power is switched on and off, but this is normal, and does not indicate a malfunction. * If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from the power outlet. Refer to “Power Supply" (p. 5). * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. * Before making the connections, be sure that the volume setting of the VOLUME knob for both amplifiers is set to “0." * When connection cables with resistors are used, the volume level of equipment connected to the inputs may be low. If this happens, use connection cables that do not contain resistors, such as those from the Roland PCS series. CUBE-15X • Rated Power Output 15 W • Nominal Input Level INPUT (CLEAN channel): -10 dBu/1 MQ AUX IN: -10 dBu • Speakers 20 cm (8 inch) • Controls POWER Switch SELECT Switch POWER SQUEEZER Switch