Войти:
Оценок - 2, средний балл: 4 ( )

Инструкция по эксплуатации Peavey, модель DPB Head

Производитель: Peavey
Размер: 1.7 mb
Название файла: d9ca6803-54f1-4b14-b8cb-f6b3f2193d82.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Greatly reduced shock hazard exists when the unit is operated with the proper grounded receptacles. DIRECT OUT (BALANCED LINE OUTPUT) (14): Provides 600 ohm, transformer balanced signal to be used as "direct" patch into mixing consoles, tape recorders,, etc. The signal at this point has been frequency compensated for low noise operation. POWER AMP INPUT (15): Use to connect line level signal to the power amplifier. PREAMP OUTPUT (16): The preamp can be used to route the signal to a mixing console, tape recorder, etc. Connect the preamp output using a shielded cable to an input of the tape recorder, mixer, etc. This patch does not affect the operation of the amplifier. EFFECTS SEND (17): Output for supplying signals to external effects or signal processing equipment. EFFECTS RETURN (18): Input for returning signals from external effects or signal processing equipment. SPEAKER OUTPUTS (19): A Provided for connection of external speaker(s). Minimum total impedance is 4 ohms. SPECIFICATIONS Control Settings for Nominal Measurements: Pre Gain = 5 Master Volume = 10 Low Shelving = 0 High Shelving = 0 Pad = Out Contour = Out Graphic = Out EFFECTS LOOP SEND: Output impedance = 100 ohms Nominal output = .316 V (-10 dBV) Maximum output = 4 V (+12 dBV) RETURN: Input impedance = 30 K ohms Nominal output = .316 V (-10 dBV) Maximum output = 4 V (+12 dBV) PREAMP Input sensitivity (-10 dB pad out) Nominal input: 80 mV (-22 dBV) Minimum input: 10 mV (-40 dBV) Maximum input: 7 V (+17 dBV) -10 dB PAD IN Nominal input: 0.25 V (-12 dBV) Minimum input: 32 mV (-30 dBV) Maximum input: 10 V (+20 dBV) EQUALIZATION Low - Shelving type ±15 dB @ 20 Hz High = Shelving type ±15 dB @ 8 kHz Graphic: ±15 dB @ center frequencies (40 Hz, 100 Hz, 250 Hz, 625 Hz, 1.6 kHz, 4 kHz, and 10 kHz) PREAMP OUT Output impedance = 100 ohms Nominal output = 1 V (0 dBV) Maximum output = 10 V (+20 dBV) POWER AMPLIFIER Input impedance = 14 K ohms Nominal input = 1 V (0 dBV) Noise Floor = -90 dBV below rated power Power Output: 200 W into 8 ohm load 300 W into 4 ohm load Frequency Response: +0 / -3 dB from 20 Hz to 18 kHz @ 200 watts System Noise = -85 dB below rated power A Due to our efforts for constant improvements, features and specifications listed herein are subject to change without notice. THIS LIMITED WARRANTY VALID ONLY WHEN PURCHASED AND REGISTERED IN THE UNITED STATES OR CANADA. ALL EXPORTED PRODUCTS ARE SUBJECT TO WARRANTY AND SERVICES TO BE SPECIFIED AND PROVIDED BY THE AUTHORIZED DISTRIBUTOR FOR EACH COUNTRY. Ces clauses de garantie ne sont vaiables qu’aux Etats-Unis et au Canada. Dans tour les autres pays, les clauses de garantie et de maintenance sont fixees par le distributee national et assuree par lul seion la legislation envigueur. Diese Garantie ist nur in den USA and Kanada gultig. Alle Export-Produkte sind der Garantie und dem Service des Importeurs des jewelligen Landes unterworfen. Esta garantía es valida solamente cuando el producto es comprado en E.U. continentales o en Canada. Todos los productos que sean comprados en el extranjero, están sujetos a las garantías y servicio que cada distribuidor autorizado determine y ofrezca en los diferentes paises. PEAVEY ONE-YEAR LIMITED WARRANTY/REMEDY PEAVEY ELECTRONICS CORPORATION (“PEAVEY") warrants this product, EXCEPT for covers, footswitches, patchcords, tubes and meters, to be free from defects in material and workmanship for a period of one (1) year from date of purchase, PROVIDED, however, that this limited warranty is extended only to the original retail purchaser and is subject to the conditions, exclusions, and limitations hereinafter set forth: PEAVEY 90-DAY LIMITED WARRANTY ON TUBES AND METERS If this product contains tubes or meters, Peavey warrants the tubes or meters contained in the product to be free from defects in material and workmanship for a period of ninety (90) days from date of purchase; PROVIDED, however, that this limited warranty is extended only to the original retail purchaser and is also subject to the conditions, exclusions, and limitations hereinafter set forth. CONDITIONS, EXCLUSIONS, AND LIMITATIONS OF LIMITED WARRANTIES These limited warranties shall be void and of no effect, if: a. The first purchase of the product is for the purpose of resale; or b. The original retail purchase is not made from an AUTHORIZED PEAVEY DEALER; or c. The product has been damaged by accident or unreasonable use. neglect, improper service or maintenance, or other causes not arising out of defects in material or workmanship; or d. The serial number affixed to the product is altered, defaced, or removed. In the event of a defect in material and/or workmanship covered by this limited warranty, Peavey will: a. In the case of tubes or meters, replace the defective component without charge. b. In other covered cases (i.e., cases involving anything other than covers, footswitches, patchcords, tubes or meters), repair the defect i...

Эта инструкция также подходит к моделям:
Музыкальные инструменты - DPB Head (1.7 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории