Войти:
Оценок - 3, средний балл: 4.7 ( )

Инструкция по эксплуатации Sony, модель MHC-GRX5

Производитель: Sony
Размер: 942.15 kb
Название файла: 3862008111.pdf
Язык инструкции:en
Перейти к скачиванию



К этому устройству также есть другие инструкции:

Фрагмент инструкции


SHUFFLE REPEAT 1 ALL 1 DISCS PROGRAM STEP VOLUME SYNC § To Do this Stop play Press p. Pause Press CD (P(Pon the remote). Press again to resume play. Select a track During play or pause, turn the jog dial clockwise (to go forward) or counterclockwise (to go back) and release it when you reach the desired track. (Or press +(to go forward) or =(to go back) on the remote.) Find a point in Press and hold down )or a track 0during play and release it at the desired point. Select a CD Press a DISC 1~3 button or in stop mode DISC SKIP/EX-CHANGE. Play only the Press PLAY MODE CD you have repeatedly until “1 DISC” selected appears. Play all CDs Press PLAY MODE repeatedly until “ALL DISCS” appears. Remove the CD Press ¤. Exchange other Press DISC SKIP/ CDs while EX-CHANGE. playing Adjust the Turn VOLUME (or press VOL volume +/– on the remote). Tips • Pressing CD (Pwhen the power is off automatically turns the power on and starts CD playback if there is a CD in the tray (One Touch Play). • You can switch from another source to the CD player and start playing a CD just by pressing CD (Por the DISC 1~3 buttons (Automatic Source Selection). • If there is no CD in the player, “CD NO DISC” appears in the display. • When a disc tray holding a CD is selected (or playing), the DISC 1~3 button for that tray lights green. When a disc tray holding a CD is not selected, the DISC 1~3 button for that tray lights orange. When all disc trays are empty, the DISC 1~3 buttons all light green. Basic Operations Recording a CD — CD Synchro Recording The CD SYNC button lets you record from a CD to a tape easily. You can use TYPE I (normal) or TYPE II (CrO2) tapes. The recording level is adjusted automatically. DISC SKIP/ (Power) p 5 EX-CHANGE 2 DOLBY NR 4 13 1 Press ¤and insert a blank tape into deck B. With the side you want to record facing forward 2 Press ¤and place a CD. Then press again to close the disc tray. If the indicator for the tray you want to record is not lit green, press DISC SKIP/ EX-CHANGE repeatedly so that it lights green. With the label side up. When you play a single CD, place it on the inner circle of the tray. 3 Press CD SYNC. Deck B stands by for recording and the CD player stands by for playback. The indicator on TAPE B ((for front side) lights up. 4 Press DIRECTION repeatedly to select Ato record on one side. Select §(or RELAY) to record on both sides. 5 Press PPAUSE. Recording starts. To stop recording Press p. Tips • If you want to record from the reverse side, press TAPE B 9to light its indicator after pressing CD SYNC. • When you record on both sides, be sure to start from the front side. If you start from the reverse side, recording stops at the end of the reverse side. • When you want to reduce the hiss noise in low- level high-frequency signals, press DOLBY NR so that “DOLBY NR” appears after pressing CD SYNC. Note You cannot listen to other sources while recording. Listening to the radio –– Preset Tuning Preset radio stations in the tuner's memory first (see “Step 3: Presetting radio stations”). (Power) 21 STEREO/MONO VOLUME 1 Press TUNER/BAND repeatedly until the band you want appears in the display. The bands you can receive vary depending on the model you purchased. Be sure to check which bands you can receive. Every time you press the button, the band changes as follows: 2 band model: FM .AM 3 band model: FM nMW nSW n or FM nMW nLW n 4 band model: FM nMW nLW nUKV* n * “STEREO PLUS” is displayed when you select UKV. 2 Turn the jog dial (or press =or +on the remote) to tune in the desired preset station. Basic Operations Turn counterclockwise + = for higher on the remote) for lower preset preset numbers. numbers. Preset number Frequency Turn clockwise (or press + A . (or press = on the remote) TUNER/BAND =+ VOLUME MHz kHzALL DISCS § To Do this Turn off the radio Press . Adjust the volume Turn VOLUME (or press VOL +/– VOL +/– on the remote). continued Listening to the radio (continued) To listen to non-preset radio stations Use manual or automatic tuning in step 2. For manual tuning, press + or – repeatedly. For automatic tuning, press and hold + or –. Tips • Pressing TUNER/BAND when the power is off automatically turns the power on and tunes to the last received station (One Touch Play). • You can switch from another source to the radio just by pressing TUNER/BAND (Automatic Source Selection). • When an FM program is noisy, press STEREO/MONO so that “MONO” appears in the display. There will be no stereo effect, but the reception will improve. Press the button again to restore the stereo effect. • To improve broadcast reception, reorient the supplied antennas. Recording from the radio You can record the radio program on a tape by calling up a preset station. You can use TYPE I (normal) or TYPE II (CrO2) tapes. The recording level is automatically adjusted. (Power) 2 146 p 35 DOLBY NR 1 Press TUNER/BAND to select the band you want. 2 Turn the jog dial to tune in a preset station. Turn counter- + = Turn clock...

Эта инструкция также подходит к моделям:
Музыкальные центры - MHC-GRX7 (942.15 kb)
Музыкальные центры - MHC-GRX9000 (942.15 kb)
Музыкальные центры - MHC-R500 (942.15 kb)
Музыкальные центры - MHC-R700 (942.15 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории