|
Фрагмент инструкции
Failure to do so can result in electrical shock or death. • Do not attempt to repair or replace any part of your chest freezer unless it is specifically recommended in this material. All other servicing should be referred to a qualified technician. • Use two or more people to move and install the chest freezer. Failure to do so can result in back or other injury. • To ensure proper ventilation for your chest freezer, the front of the unit must be completely unobstructed. Choose a well-ventilated area with temperatures above 550F (130C) and below 900F (32 0C). This unit must be installed in an area protected from the elements, such as wind, rain, water spray or sunlight. • The chest freezer should not be located next to ovens, grills or other sources of high heat. • The chest freezer must be installed with all electrical, water and drain connections in accordance with state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in accordance with the National Electrical Code and local codes and ordinances is required. • Do not kink or pinch the power supply cord of the chest freezer. • The fuse (or circuit breaker) size should be 15 amperes. • It is important for the chest freezer to be leveled in order to work properly. You may need to make several adjustments to level it. • All installation must be in accordance with local plumbing code requirements. • Make certain that the pipes are not pinched or kinked or damaged during installation. • Check for leaks after connection. • Never allow children to operate, play with or crawl inside the chest freezer • Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damage or discolor the interior. • Do not use this apparatus for other than its intended purpose. IMPORTANT SAFETY INSTRUCTIONS .WARNING. To reduce the risk of fire, electrical shock, or injury when using your freezer, follow these basic precautions: • Read all instructions before using the freezer. DANGER or WARNING: Risk of child entrapment. Child entrapment and suffocation are not problems of the past. Junked or abandoned freezers are still dangerous, even if they will “just sit in the garage a few days.” • Before you throw away your old freezer: Take off the doors. Leave the shelves in place so that children may not easily climb inside. • Never allow children to operate, play with, or crawl inside the freezer. • Never clean freezer parts with flammable fluids. The fumes can create a fire hazard or explosion. • Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other freezer. The fumes can create a fire hazard or explosion. -Save these instructions- INSTALLATION INSTRUCTIONS Before Using Your Freezer • Remove the exterior and interior packing. • Check to be sure you have all of the following parts: . 1 Storage Basket . 1 Instruction Manual . 1 Plastic Scraper • Before connecting the freezer to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth. Installing Your Freezer • This appliance is designed to be free standing only, and should not be recessed or built-in. • Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded. • Allow 5 inches of space between the back and sides of the freezer, which allows the proper air circulation. • Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the freezer not to perform properly. • Avoid locating the freezer in moist areas. • Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. • After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before placing food in the freezer compartment. Electrical Connection This freezer should be properly grounded for your safety. The power cord of this freezer is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third ground prong from the power cord supplied. This freezer requires a standard 115/120Volt~60Hz electrical outlet with three-prong ground. The cord should be secured behind the freezer and not left exposed or dangling to prevent accidental injury. Never unplug the freezer by pulling the power cord. Always grip the plug firmly and pull straight out from the receptac...
Эта инструкция также подходит к моделям:Морозильные камеры - CF205 (365.47 kb)
Морозильные камеры - CF205 (365.47 kb)
Морозильные камеры - CF205 (365.47 kb)
Морозильные камеры - CF205 (365.47 kb)