Оценок - 4, средний балл: 3.5 ( )

Производитель: Delfield Размер: 460.79 kb Название файла: cf208g1.pdf Язык инструкции:

· Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded. · Allow 5 inches of space between the back and sides of the appliance, which allows the proper air circulation to cool the compressor and condenser. · Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the freezer not to perform properly. · Avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form quickly on the evaporator requiring more frequent defrosting of the freezer. · Plug the appliance into an exclusive properly installed grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. · After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before placing food in the freezer compartment. Electrical Connection .Warning. Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by an authorized Avanti Products service center. This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third ground prong from the power cord supplied. This freezer requires a standard 115Volts~/60Hz electrical outlet with three-prong ground. The cord should be secured behind the freezer and not left exposed or dangling to prevent accidental injury. Never unplug the freezer by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Do not use an extension cord with this freezer. If the power cord is too short, have a qualified electrician or service technician install an outlet near the freezer. The “POWER” light indicates that the freezer is properly connected to the electrical power. The light indicates power supply, and will glow even if the temperature control dial is turned to “OFF”, or the compressor has failed to work and the compartment is not being cooled. . Extension Cord Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this unit. However, if you must use an extension cord it is absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes. OPERATING YOUR FREEZER Temperature Control • Your freezer has one control for regulating the temperature. The temperature control is located on the lower right hand corner. • The first time you turn the unit on, switch on the Fast Freeze switch and run for at least 2 hours before putting frozen foods inside. This will ensure the cabinet is thoroughly chilled before food is put in. • Turn off the Fast Freeze switch. • The range of the temperature control is from position" 1" the warmest to "5" the coldest. Adjust the temperature control to the setting that best suits your needs. The setting of “3” should be correct for home or office freezer use. • To turn the freezer off, turn the temperature control to "OFF". NOTE: . Turning the temperature control to "OFF" position stops the cooling cycle but does not shut off the power to the freezer. . If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the freezer will not start. . Large amounts of food will lower the cooling efficiency of the appliance. . If you choose to change the thermostat setting, adjust thermostat control by one numerical increment at a time. Allow several hours for temperature to stabilize between adjustments. Temperature Control Panel Cover To prevent accidental changes to temperature control, a clear plastic cover has been included with your appliance. • To install the cover, align the plastic cover above the temperature control panel and slide down. • To remove the cover, slide up and away from the temperature control panel. The Fast Freeze Switch • The amber light will glow while the Fast Freeze switch is in the ‘ON’ position. • The switch overrides the thermostat and will make the compressor operate continuously, lowering the cabinet temperature still further than the thermostat setting. • This switch is used to freeze unfrozen food in appreciable quantities. • When loading the freezer, freeze only three pounds of fresh food per cubic foot of freezer space at one time. • Distribute packa...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: