Оценок - 5, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
The absence of frost is due to the continuous circulation of cold air inside the compartment, driven by an automatically controlled fan. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: • disconnect the appliance from electricity supply • remove all food • defrost5) and clean the appliance and all accessories • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF… WARNING! Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. Problem Possible cause Solution The appliance does not The appliance is switched off. Switch on the appliance. operate. 5) If foreseen. What to do if… 13 Problem Possible cause Solution The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. Connect a different electrical ap- There is no voltage in the mains pliance to the mains socket. socket. Contact a qualified electrician. The Alarm light flashes. The temperature in the freezer is Refer to "High temperature too high. alarm" The compressor operates The temperature is not set cor-Set a higher temperature. continually. rectly. The door is not closed correctly. Refer to "Closing the door". The door has been opened too Do not keep the door open longer frequently. than necessary. The product temperature is too Let the product temperature de- high. crease to room temperature before storage. The room temperature is too Decrease the room temperature. high. The FROSTMATIC function is Refer to "FROSTMATIC function". switched on. The temperature in the The temperature regulator is not Set a higher temperature. freezer is too low. set correctly. The FROSTMATIC function is Refer to "FROSTMATIC function". switched on. The temperature in the The temperature regulator is not Set a lower temperature. freezer is too high. set correctly. The door is not closed correctly. Refer to "Closing the door". The product temperature is too Let the product temperature de- high. crease to room temperature before storage. Many products are stored at the Store less products at the same same time. time. Products are too near to each Store products so that there is other. cold air circulation. Upper or lower square is An error has occurred in meas- Call your service representative shown in the temperature uring the temperature. (the cooling system will continue display. to keep food products cold, but temperature adjustment will not be possible). 14 14 Technical data Problem Possible cause Solution dEMo appears on the Dis- The appliance is in demonstra- Keep pressed approximately 10 play. tion mode (dEMo). sec. the OK button since a long sound of buzzer is heard and the Display shut off for a short while: appliance start works regularly. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center. TECHNICAL DATA Dimension of the recess Width 550 mm Depth 575 mm Rising Time 21 h Voltage 230-240 V Frequency 50 Hz Height 1855 mm The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION Positioning WARNING! If you are discarding an old appliance that has a lock or catch on the door, you must ensure that it is made unusable to prevent young children being trapped inside. The appliance shall have the plug accessible after installation. Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C Installation 15 Climate class Ambient temperature ST +16°C to + 38°C T +16°C to + 43°C Electrical Connection CAUTION! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. The wires in the mains lead are coloured in accordance with the following code: 1 Green and Yellow: Earth 35 Brown: Live Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured r...