|
Фрагмент инструкции
Do not operate the monitor at temperatures below -20oC or above +70oC. 2. Keep the monitor clean and dry. 3. Always seek qualified personnel to perform repairs. Never attempt your repairs. 4. Do not drop the monitor or expose to strong impacts. 5. Do not expose to direct sunlight for extended periods of time. -2 AUX Cable AUX Cable (External VCR device connection wire) 1) Type of Cable : Two RCA to One Stereo Cable. -3 OSD Menu Structure Monitor Panel Control ( - button ) ( + button ) -4 On Screen Display This page describes the function of the control keys and the OSD menu structure. The relevant menu (video or nav) will be detected automatically, depending on the input mode given by the display control line or by VCR- connector. Monitor Settings The color display is equipped with On-Screen Display (OSD) prompting for the monitor settings. There are 3 buttons on top of the monitor. These will be used for the OSD control. They are as follows: “Menu” = Menu “ + “ = Plus “–“ = Minus “Menu” button is used to select the desired function. The desired function will be highlighted in red. “+” And “-“ buttons are used to adjust the desired function. Note: If a button has not been pressed for 5 seconds, then the OSD menu is automatically hidden again. -5 Invoking OSD menu Briefly press the menu button on top of the monitor. The OSD menu “ Navigation settings” is displayed and Volume will be highlighted in Red. In the OSD menu you can adjust the following settings: * Volume: Adjust Volume level of the built-in monitor loudspeaker * Brightness: Adjust brightness of the display. * Display mode: Screen display; the selected setting is indicated in red. Possible selections include: “Full Screen “ (16:9) “Normal” (4:3) Adjusting settings 1. Press the Menu button until the desired function appears in red. 2. Adjust the desired setting with the + or – buttons. If necessary, invoke the next menu item by pressing the Menu Button. -6 * If you use the built-in monitor loudspeaker, leave the volume level in the OSD menu on the middle setting. Adjust the volume level for the audible messages of the navigation system with the + or – buttons on the remote control. * The volume level of the built in monitor speaker can also be set without invoking the OSD menu. Press the + or – button on the monitor. The display automatically changes to the menu for setting the volume. Set the volume desired by pressing the + or – buttons. Set up Menu The monitor offers you the possibility of performing the following settings in the Setup Menu: * Brightness Control: Day/Night * Loudspeaker: On/Off -7 Invoking the Setup Menu Press all three buttons at the top of the monitor at the same time. The Setup Menu appears Brightness will be highlighted in red. Press + or – to select Day or Night highlighted in red. Day selection will be bright, Night will be dark. Note: If brightness control is set for Night, It will return to Day mode whenever the Ignition is turned off for more then 30 seconds. ...
Эта инструкция также подходит к моделям:Мониторы - LCM58N (196.67 kb)
Мониторы - LCM5N (196.67 kb)
Мониторы - LCM5N (196.67 kb)