Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Мониторы - 29UM65-P (6.05 mb)
Мониторы - 29UM65-P (6.69 mb)
Фрагмент инструкции
(Silver) Stand Body CAUTION 3 Remove the two screws on the back of stand body. As shown in the illustration, disconnect the stand body from the stand hinge. yyIllustrations in this document represent typical procedures, so they may look different from the actual product. yyDo not carry the monitor upside down by just holding the stand base. This may cause the monitor to fall off the stand and could result in personal injury. yyWhen lifting or moving the monitor, do not touch the monitor screen. Applying force or pressure may damage the monitor screen. Instead, hold the stand body or the plastic frame of the product. Stand Hinge Stand Body (Black) or (Black) 3 Remove the two screws from the stand body. 29UB65 1 Place the screen face down. Stand Body CAUTION yyTo protect the screen from scratches, cover the surface with a soft cloth. 2 Turn the screw to the left using a coin. Detach the stand base. 1 2 Stand Body CAUTION yyThe components in the illustrations may differ from the actual product. yyDo not carry the monitor upside down, as this may cause it to fall off its stand and result in damage or injury. yyTo avoid damaging the screen when lifting or moving the monitor, only hold the stand or the plastic cover. This avoids putting unnecessary pressure on the screen. Stand Base Installing onto a table 1 Lift the monitor and place it on the table in an upright position. Place at least 10 cm away from the wall to ensure sufficient ventilation. 2 Connect the adapter to the monitor, then plug the power cord into the power outlet. 29UM65 29UM65 10 cm 10 cm 10 cm 10 cm 29UB65 29UB65 3 Press the (Power) button on the bottom of the monitor to turn it on. 10 cm 10 cm 10 cm CAUTION 10 cm yyUnplug the power cord prior to moving or installing the monitor. There is risk of electric shock. 3 The height can be adjusted up to 110.0 mm. Adjusting the stand height 110.0 mm 29UB65 1 Stand the monitor assembled with the stand base in an upright position 2 Remove the tape attached to the bottom back of the stand body and then pull out the locking pin while pressing the head downward. CAUTION yyOnce the pin is removed, it is not necessary to re-insert it to adjust the height. Stand Body Tape WARNING Locking Pin yyDo not put your fingers or hand between the screen and the base (chassis) when adjusting the screen's height. Head Locking pin Adjusting the angle 1 Place the monitor in an upright position, mounted on the stand base. WARNING yyTo avoid injury to the fingers when adjusting the screen, do not hold the lower part of the monitor's frame as illustrated below. 2 Adjust the angle of the screen. The angle of the screen can be adjusted forwards or backwards for a comfortable viewing experience. 29UM65 29UM65 -520 Rear Side Front Side 29UB65 29UB65 yyBe careful not to touch or press the screen area when adjusting the angle of the monitor. 29UM65 Rear Side Fro...
Эта инструкция также подходит к моделям:Мониторы - 29UM65 (6.15 mb)
Мониторы - 29UM65-W (6.15 mb)
Мониторы - 29UB65 (6.15 mb)
Мониторы - 29UB65-P (6.15 mb)