Оценок - 4, средний балл: 3.8
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
6. The next screen is for setting your monitor. 7. Set a horizontal frequency for your monitor. (You can enter the frequency directly.) 8. Set a vertical frequency for your monitor. (You can enter the frequency directly.) 9. Enter the model name of your monitor. This information will not affect the actual execution of X-Window. 10. You have finished setting up your monitor. Execute X-Window after setting other requested hardware. Installation 1. Insert the installation CD into the CD-ROM drive. 2. Click the MDC installation file. Note If the installation window does not appear, access the CD using Windows Explorer, and then double click the MDC executable file on the CD to launch the installation. 3. When the Installation Shield Wizard window appears, click "Next". 4. Select "I agree to the terms of the license agreement" to accept the terms of use. 5. Click "Install". 6. The "Installation Status" window appears. 7. Click "Finish". 8. When the installation is complete, the MDC executable icon appears on your desktop. Double-click the icon to start the program. The MDC execution icon may not appear depending on the specifications of your computer system or monitor. If this happens, press the F5 Key. Installation Problems The installation of MDC can be affected by such factors as the video card, motherboard and the network environment. Uninstall To uninstall the MDC program, use the "Add or Remove Programs" option in the Windows ® Control Panel. Note If you press Escape or do not touch the sensor within twenty seconds, the system automatically cancels the calibration process with no change to the current settings. 4. Touch the sensor positioning your fingertip to completely cover the green target. This position is calculated upon liftoff and when you remove your finger, the target should turn red. When touching the calibration target, make sure to: • Perform the calibration in the position (sitting or standing) you expect to normally use the touch sensor. • Touch the calibration target firmly and precisely with your fingertip. During Calibration, be careful to keep your fingernails and other fingers away from the touch sensor as you touch the target. 5. Repeat these instructions for additional calibration targets. 6. Once you have calibrated the touch sensor, a dialog box will appear to ask if you wish to test, accept or cancel this calibration. • If you select Accept, then the new calibration settings are automatically accepted. • If you select Test, then a Draw (refer to the Tools tab for more details) screen appears. When you exit Draw mode, a dialog will prompt, “Are you satisfied with the results?” • Selecting Yes will keep the new calibration settings. • Selecting No will restore the original (pre-calibration) settings. • If you select Cancel, the original settings will be restored without change. Testing the Calibration If you accidentally liftoff from the sensor in the wrong place during calibration, you will distort the touch sensor calibr...
Эта инструкция также подходит к моделям:Мониторы - 230TSN (3.64 mb)